𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Influence of machining parameters on surface roughness in finish cut of WEDM

✍ Scribed by Fuzhu Han; Jun Jiang; Dingwen Yu

Publisher
Springer
Year
2006
Tongue
English
Weight
488 KB
Volume
34
Category
Article
ISSN
0268-3768

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Experimental investigation of effects of
Experimental investigation of effects of cutting parameters on surface roughness in the WEDM process
✍ Mustafa Δ°lhan GΓΆkler; Alp Mithat OzanΓΆzgΓΌ πŸ“‚ Article πŸ“… 2000 πŸ› Elsevier Science 🌐 English βš– 352 KB

The experimental study presented in this paper aims to select the most suitable cutting and offset parameter combination for the wire electrical discharge machining process in order to get the desired surface roughness value for the machined workpieces. A series of experiments have been performed on

Examination of machining parameters on s
Examination of machining parameters on surface roughness in EDM of tool steel
✍ M. Kiyak; O. Γ‡akΔ±r πŸ“‚ Article πŸ“… 2007 πŸ› Elsevier Science 🌐 English βš– 301 KB

Electrical discharge machining (EDM) is one of the important non-traditional machining processes and it is widely accepted as a standard machining process in the manufacture of forming tools to produce molds and dies. Since its introduction to manufacturing industry in late 1940s, EDM became a well-

Influence of surface preparation on roug
Influence of surface preparation on roughness parameters, friction and wear
✍ M. Sedlaček; B. Podgornik; J. ViΕΎintin πŸ“‚ Article πŸ“… 2009 πŸ› Elsevier Science 🌐 English βš– 969 KB

The aim of the present research was to investigate influence of surface preparation on roughness parameters and correlation between roughness parameters and friction and wear. First the correlation between different surface preparation techniques and roughness parameters was investigated. For this p