Influence of alkali, silicate, and sulfate content of carbonated concrete pore solution on mild steel corrosion behavior

✍ Scribed by B. Huet; V. L'Hostis; L. Tricheux; H. Idrissi

• Publisher: John Wiley and Sons
• Year: 2009
• Tongue: German
• Weight: 867 KB
• Volume: 61
• Category: Article
• ISSN: 0947-5117
• DOI: 10.1002/maco.200905244

✦ Synopsis

Abstract

The increase in the rebar corrosion rate due to the concrete carbonation is the major cause of reinforced concrete degradation. The aim of this study was to investigate the corrosion behavior of mild steel rebars in simulated carbonated concrete solution. For this purpose, thermodynamic calculations, electrochemical techniques, gravimetric measurements, and surface analyses were used. Thermodynamic investigations of the nature of the interstitial solution provides an estimation of the influence of sulfate (${\rm SO}_4^{2 - }$) and alkali (Na^+^, K^+^) content on carbonate alkalinity of the CO~2~/H~2~O open system (pCO~2~ = 0.3 mbar). In this system, calcium‐silicate hydrates (C–S–H) remain thermodynamically unstable and amorphous silica controls silicate aqueous content at 100 ppm. Electrochemical results highlight a decrease in the corrosion rate with increasing carbonate alkalinity and the introduction of silicate. The introduction of sulfate at fixed carbonate alkalinity shows a dual effect: at high carbonate alkalinity, the corrosion rate is increased whereas at low carbonate alkalinity, corrosion rate is decreased. Those results are supported by surface analysis. Authors conclude that silicate and sulfate release from cement hydrates and fixation of alkali on carbonated hydrates are key parameters to estimate mild steel corrosion in carbonated concrete.