𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Influence of a biopolymer admixture on corrosion behaviour of steel rebars in concrete

✍ Scribed by S. Roux; N. Bur; G. Ferrari; B. Tribollet; F. Feugeas


Publisher
John Wiley and Sons
Year
2010
Tongue
German
Weight
437 KB
Volume
61
Category
Article
ISSN
0947-5117

No coin nor oath required. For personal study only.

✦ Synopsis


Among the multitude of concrete structure pathologies, corrosion of rebars is one of the most important problems of concrete durability. In the context of sustainable development, it appears of primary importance to develop new means to protect the rebars against corrosion. This study aims to develop a new eco-friendly and corrosion-inhibiting admixture based on EPS 180 exopolysaccharides, biopolymers used in coatings already studied for the corrosion inhibition on steel in seawater. C15 rebars embedded in CEMI and CEMV cement paste containing EPS 180 were immersed in natural seawater and their electrochemical behaviour was studied using open circuit potential measurements and electrochemical impedance spectroscopy. These tests highlight the decrease of the cathodic reaction kinetics due to the EPS 180 action at the rebars surface, and the absence of effect on the passive layer. Capillary imbibition tests carried out on cement paste and mortars showed that although limiting the imbibition kinetics for cement pastes, the EPS 180 did not influence the water imbibition of mortars. Tests comparing capillary imbibition of soaked cement pastes and mortars with EPS 180 solution and the same samples containing the EPS 180 admixture highlight that the corrosion inhibition induced by EPS 180 admixture is more due to the modification of the cement -rebars interface than to the clogging of the cement porous network.


πŸ“œ SIMILAR VOLUMES


Influence of the chromate content in cem
✍ P. Schieß; T. F. Mayer; K. Osterminski πŸ“‚ Article πŸ“… 2008 πŸ› John Wiley and Sons 🌐 German βš– 360 KB πŸ‘ 1 views

## Abstract Chromate, which is known to be an effective corrosion inhibitor in various applications, is contained in cement as a trace element. So far its influence on the corrosion of steel in contact with concrete has not been investigated. However, as the introduction of chromate‐reduced cements

Performance of galvanized and stainless
✍ V. Saraswathy; Ha-Won Song πŸ“‚ Article πŸ“… 2005 πŸ› John Wiley and Sons 🌐 German βš– 227 KB πŸ‘ 1 views

In the recent past, the damage caused by rebar corrosion in concrete structures has been considered as one of the major durability problems affecting the service life of concrete structures. In order to prevent corrosion of steel reinforcement, various types of protective methods have been adopted.

The influence of alloying elements on th
✍ S. Sroda; D. Baxter; M. Arponen πŸ“‚ Article πŸ“… 2005 πŸ› John Wiley and Sons 🌐 German βš– 392 KB πŸ‘ 1 views

## Abstract The low‐chromium steels (Cr content 0.7–1.4 wt.%) are usually being used in low temperature boiler applications where the environments are not so aggressive as in waste‐fire boilers. To improve their mechanical properties and corrosion resistance several alloying elements have been used

Influence of chromium, molybdenum and co
✍ S. Peissl; G. Mori; H. Leitner; R. Ebner; S. EglsΓ€er πŸ“‚ Article πŸ“… 2006 πŸ› John Wiley and Sons 🌐 German βš– 373 KB πŸ‘ 1 views

High chromium martensitic steels are designed to provide high corrosion resistance in combination with high strength. Some of these steel grades contain primary carbides for improving the wear resistance, e.g. the steel 440C. The present paper mainly deals with the effect of chemical composition and

Effect of humidity and chloride content
✍ Ø. Vennesland; J. Havdahl πŸ“‚ Article πŸ“… 2009 πŸ› John Wiley and Sons 🌐 German βš– 133 KB πŸ‘ 1 views

## Abstract Measurements have been made with mortar specimens with light aggregates (LWA) and the cements Norcem HS65 and MP30, corresponding to CEM I and CEM II. The w/b ratio was 0.30 and 0.40 and in one mix prewetted LWA was used. The silica fume addition was 8%. The specimens have two sets of e

The effects of various formwork surfaces
✍ S. Subaşı; M. Arslan; G. Durmuş πŸ“‚ Article πŸ“… 2010 πŸ› John Wiley and Sons 🌐 German βš– 448 KB πŸ‘ 1 views

## Abstract In this study, the effects of various formwork surfaces on the corrosion performance of reinforcing steel in concrete were examined. For this purpose, seven formwork surfaces from populus nigra, pinus silvestris, steel sheet, and four of plywoods were prepared. Three of the plywood form