𝔖 Bobbio Scriptorium

✦ LIBER ✦

Increase of error in lignin measurement using ultraviolet microscopy due to multiple scanning

✍ Scribed by Wolfgang Gindl; Takashi Okuyama

Book ID: 105111733
Publisher: Springer
Year: 1999
Tongue: English
Weight: 140 KB
Volume: 45
Category: Article
ISSN: 1435-0211
DOI: 10.1007/bf01192338

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Errors in measuring time intervals due t

Errors in measuring time intervals due to nonlinearity of oscillograph scanning

✍ E. É. Goller; A. Ya. Sidorin 📂 Article 📅 1973 🏛 Springer US 🌐 English ⚖ 324 KB

Errors in measurements of infrared and u

Errors in measurements of infrared and ultraviolet spectra due to absorption of radiation by solvent

✍ B. V. Lopatin 📂 Article 📅 1971 🏛 Springer US 🌐 English ⚖ 274 KB

Using Confocal Laser Scanning Microscopy

Using Confocal Laser Scanning Microscopy to Measure Apoplastic pH Change in Roots of Lupinus angustifolius L. in Response to High pH

✍ Q. Yu; J. Kuo; C. Tang 📂 Article 📅 2001 🏛 Oxford University Press 🌐 English ⚖ 589 KB

New method of analysis for the error due

New method of analysis for the error due to spectral mismatch in short-circuit current measurement using the reference solar cell method

✍ Ryuichi Shimokawa; Masahiro Horiguchi; Yoshihiro Hamakawa 📂 Article 📅 1985 🏛 Elsevier Science ⚖ 336 KB

Use of nonsingular boundary integral for

Use of nonsingular boundary integral formulation for reducing errors due to near-field measurements in the boundary element method based near-field acoustic holography

✍ Kang, Sung-Chon; Ih, Jeong-Guon 📂 Article 📅 2001 🏛 American Institute of Physics 🌐 English ⚖ 476 KB

Oxygen interaction of CdS-based gas sens

Oxygen interaction of CdS-based gas sensors with different stoichiometric compositions was studied by X-ray photoelectron spectroscopy (XPS) and thermal-desorption mass spectroscopy observations combined with conductivity measurements. Three different types of film with different atomic ratios of Cd/S were used in the study of oxygen chemisorption in a low-temperature range between 300 and 570 K. Spray pyrolysis was used for the deposition of the films on glass substrates; XPS and energy dispersive spectroscopy of X-ray together with atomic force microscopy and scanning electron microscopy were used for the characterization of the composition and structure of the films. It was possible to distinguish different temperature ranges for the thermal desorption of the different adsorbed oxygen species. A comparison of the data from XPS and mass-spectroscopy observations with conductance measurements allows to conclude that metallic surface atoms are responsible for different interactions of oxygen species with CdS surfaces.

📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 379 KB