Fast-setting calcium phosphate cement (FSCPC) is a promising new bioactive cement with a significantly short setting time (approximately 5-6 min) compared to conventional calcium phosphate cement (c-CPC) (30-60 min) at physiologic temperatures. As a result of its ability to set quickly, it is applic
In vivo bone response to porous calcium phosphate cement
✍ Scribed by R. P. del Real; E. Ooms; J. G. C. Wolke; M. Vallet-Regí; J. A. Jansen
- Publisher
- John Wiley and Sons
- Year
- 2003
- Tongue
- English
- Weight
- 211 KB
- Volume
- 65A
- Category
- Article
- ISSN
- 1549-3296
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
We conducted an in vivo experiment to evaluate the resorption rate of a calcium phosphate cement (CPC) with macropores larger than 100 μm, using the CPC called Biocement D (Merck Biomaterial, Darmstadt, Germany), which after setting only shows pores smaller than 1 μm. The gas bubble method used during the setting process created macroporosity. Preset nonporous and porous cement implants were inserted into the trabecular bone of the tibial metaphysis of goats. The size of the preset implants was 6 mm and the diameter of the drill hole was 6.3 mm, leaving a gap of 0.3 mm between implant surface and drill wall. After 2 and 10 weeks, the animals were euthanized and cement implants with surrounding bone were retrieved for histologic evaluation. Light microscopy at 2 weeks revealed that the nonporous implants were surrounded by connective tissue. On the cement surface, we observed a monolayer of multinucleated cells. Ten weeks after implantation, the nonporous implants were still surrounded by connective tissue. However, a thin layer of bone now covered the implant surface. No sign of cement resorption was observed. In contrast, the porous cement evoked a completely different bone response. At 2 weeks, bone formation had already occurred inside the implant porosity. Bone formation even appeared to occur as a result of osteoinduction. Also, at their outer surface, the porous implants were completely surrounded by bone. At 2 weeks, about 31% of the initial cement was resorbed. After 10 weeks, 81% of the initial phosphate cement was resorbed and new bone was deposited. On the basis of these observations, we conclude that the creation of macropores can significantly improve the resorption rate of CPC. This increased degradation is associated with almost complete bone replacement. © 2003 Wiley Periodicals, Inc. J Biomed Mater Res 65A: 30–36, 2003
📜 SIMILAR VOLUMES
## Abstract The aim of this study was to determine the impact of barium sulfate on remodeling and regeneration in standard tibial defects in rabbits treated with the Norian skeletal repair system (SRS). Two formulations of SRS (with and without barium sulfate) were injected into the medullary canal
## Abstract We have recently developed a new calcium phosphate bone cement enriched with gelatin (GEL‐CP), which exhibits improved mechanical properties with respect to the control cement (C‐CP). In a previous study, we demonstrated the good response of osteoblast‐like cells to the new biomimetic b
Two calcium phosphate cements, one monophasic and the other biphasic, have been used as bone void filler in a sheep model. The cements were injected into a slot defect in the proximal tibia and into a cylindrical defect in the distal femur. In this study, we focused on the resorption pattern of the
## Abstract The objective of this study was to evaluate the effect of radio frequency sputtered calcium phosphate (CaP) coatings of titanium (Ti) implants on the bond strength at the bone–implant interface and percent bone contact length. Cylindrical coated or noncoated implants (4.0‐mm diameter by
## Abstract Six different tetracalcium phosphate (TTCP) products were synthesized by solid state reaction at high temperature by varying the overall calcium to phosphate ratio of the synthesis mixture. The objective was to evaluate the effect of the calcium to phosphate ratio on a TTCP‐dicalcium ph