✦ LIBER ✦

In-process dimensional control of the workpiece during turning

✍ Scribed by K.C. Fan; Y.H. Chao

Publisher: Elsevier Science
Year: 1991
Tongue: English
Weight: 500 KB
Volume: 13
Category: Article
ISSN: 0141-6359
DOI: 10.1016/0141-6359(91)90218-8

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

STABILITY ANALYSIS OF SPINNING STEPPED-S

STABILITY ANALYSIS OF SPINNING STEPPED-SHAFT WORKPIECES IN A TURNING PROCESS

✍ Z.C. WANG; W.L. CLEGHORN 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 216 KB

In-process measurement and workpiece-ref

In-process measurement and workpiece-referred form accuracy control system (WORFAC): application to cylindrical turning using an ordinary lathe

✍ Yutaka Uda; Tsuguo Kohno; Takanori Yazawa 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 465 KB

On-line identification and control of dy

On-line identification and control of dynamic characteristics of slender workpieces in turning

✍ Cornel Mihai Nicolescu 📂 Article 📅 1996 🏛 Elsevier Science 🌐 English ⚖ 852 KB

Control of the traverse grinding process

Control of the traverse grinding process using dynamically active workpiece steadies

✍ Y. Gao; B. Jones 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 765 KB

In-process measurements of wall thicknes

In-process measurements of wall thickness deviations during turning

✍ D. Stöbener; G. Goch 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 221 KB

## Abstract During the turning process of a ring, the clamping force of the chuck causes circumferential deviations in the ring wall thickness and diameter. This paper focuses on an ultrasonic in‐process measuring system which is a prerequisite for in‐process compensation of the wall thickness devi

Scope of in-process measurement, monitor

Scope of in-process measurement, monitoring and control techniques in machining processes—Part 2: In-process techniques for workpieces

✍ M. Shiraishi 📂 Article 📅 1989 🏛 Elsevier Science 🌐 English ⚖ 1008 KB