✦ LIBER ✦

In-process detection and suppression of chatter in milling

✍ Scribed by Y. Altintas; Philip K. Chan

Publisher: Elsevier Science
Year: 1992
Tongue: English
Weight: 945 KB
Volume: 32
Category: Article
ISSN: 0890-6955
DOI: 10.1016/0890-6955(92)90006-3

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Analysis of chatter vibration in the end

Analysis of chatter vibration in the end milling process

✍ An-Chen Lee; Chia-Shang Liu 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 416 KB

Detection of chatter vibration in end mi

Detection of chatter vibration in end milling applying disturbance observer

✍ Yasuhiro Kakinuma; Yui Sudo; Tojiro Aoyama 📂 Article 📅 2011 🏛 International Academy for Production Engineering 🌐 English ⚖ 460 KB

Chatter detection in milling based on th

Chatter detection in milling based on the probability distribution of cutting force signal

✍ Ruxu Du; M.A. Elbestawi; B.C. Ullagaddi 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 776 KB

Fuzzy stability analysis of regenerative

Fuzzy stability analysis of regenerative chatter in milling

✍ Neil D. Sims; Graeme Manson; Brian Mann 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 960 KB

CHATTER PREDICTION OF END MILLING IN A V

CHATTER PREDICTION OF END MILLING IN A VERTICAL MACHINING CENTER

✍ S.K. KIM; S.-Y. LEE 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 512 KB

The development of a high-speed and high-precision vertical machining center had been executed as a national project in Korea. In the machining center, the phenomenon of chatter vibration was an important factor, and should be examined for developing it by a relevant way. In a high-speed and high-pr

Chatter suppression in five-axis machini

Chatter suppression in five-axis machining of flexible parts

✍ F. Ismail; R. Ziaei 📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 274 KB

In this work on line and off line measures for chatter suppression in cutting flexible turbine blades on a five-axis machine were implemented. The off line measure was implemented by increasing the feed rate at times when the rotary axes were undergoing large increments. A spindle speed ramping cont