𝔖 Bobbio Scriptorium
✦   LIBER   ✦

High speed end milling of hardened AISI D2 tool steel (∼58 HRC)

✍ Scribed by P Koshy; R.C Dewes; D.K Aspinwall

Book ID
108469160
Publisher
Elsevier Science
Year
2002
Tongue
English
Weight
328 KB
Volume
127
Category
Article
ISSN
0924-0136

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Effect of the minimum quantity lubricati
Effect of the minimum quantity lubrication in high-speed end-milling of AISI D2 cold-worked die steel (62 HRC) by coated carbide tools
✍ M.C. Kang; K.H. Kim; S.H. Shin; S.H. Jang; J.H. Park; C. Kim 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 692 KB

Hybrid coating method Ti-Al-N and Ti-Al-Si-N High-speed end-milling Minimum quantity lubrication (MQL) Tool wear The objective of this paper is to compare the tool performance of Ti 0.75 Al 0.25 N and Ti 0.69 Al 0.23 Si 0.08 N coated carbides end-mills deposited by hybrid coating method, using floo

Effects of workpiece preheating on surfa
Effects of workpiece preheating on surface roughness, chatter and tool performance during end milling of hardened steel D2
✍ A.K.M. Nurul Amin; Shuriani Binti Dolah; Marlina Binti Mahmud; M.A. Lajis 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 976 KB

This paper presents the results of experimental investigations conducted on a vertical machining centre (VMC) to ascertain the effectiveness of brazed circular polycrystalline cubic boron nitride (PCBN) inserts in end milling of hardened steel AISI D2 (60-62 HRC), under room temperature and workpiec