✦ LIBER ✦

Heterogeneous condensation in cooled laminar tube flow: A comparison of two aerosol modeling techniques

✍ Scribed by F. Stratmann; E. Whitby

Book ID: 115948865
Publisher: Elsevier Science
Year: 1989
Tongue: English
Weight: 215 KB
Volume: 20
Category: Article
ISSN: 0021-8502
DOI: 10.1016/0021-8502(89)90746-5

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Simultaneous convection, diffusion, ther

Simultaneous convection, diffusion, thermophoresis and heterogeneous condensation of polydisperse aerosols in cooled laminar tube flow

✍ F. Stratmann; H. Fissan; E. Otto 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 236 KB

Comparison between single-phase and two-

Comparison between single-phase and two-phases CFD modeling of laminar forced convection flow of nanofluids in a circular tube under constant heat flux

✍ Keshavarz Moraveji, Mostafa; Esmaeili, Elahe 📂 Article 📅 2012 🏛 Elsevier Science 🌐 English ⚖ 647 KB

A numerical technique for analysis of tr

A numerical technique for analysis of transient two-phase flow in a vertical tube using the Drift Flux Model

✍ S. Talebi; H. Kazeminejad; H. Davilu 📂 Article 📅 2012 🏛 Elsevier Science 🌐 English ⚖ 458 KB

Effect of void fraction models on the tw

Effect of void fraction models on the two-phase friction factor of R134a during condensation in vertical downward flow in a smooth tube

✍ A.S. Dalkilic; S. Laohalertdecha; S. Wongwises 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 724 KB

Comparison of frictional pressure drop m

Comparison of frictional pressure drop models during annular flow condensation of R600a in a horizontal tube at low mass flux and of R134a in a vertical tube at high mass flux

✍ A.S. Dalkilic; O. Agra; I. Teke; S. Wongwises 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 488 KB

This study compares well-known two-phase pressure drop models with the experimental results of a condensation pressure drop of (i) R600a in a 1 m long horizontal smooth copper tube with an inner diameter of 4 mm, outer diameter of 6 mm and (ii) R134a in a 0.5 m vertical smooth copper tube with an in