๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Heat transfer characteristics and process requirements of hot-filled guava pulp

โœ Scribed by N. NATH; SIDDALINGU; S. RANGANNA


Book ID
108805813
Publisher
John Wiley and Sons
Year
2007
Tongue
English
Weight
475 KB
Volume
18
Category
Article
ISSN
0950-5423

No coin nor oath required. For personal study only.


๐Ÿ“œ SIMILAR VOLUMES


Characteristics of heat transfer and tem
โœ Masanori Monde; Yuichi Mitsutake; Peter Lloyd Woodfield; Shinichi Maruyama ๐Ÿ“‚ Article ๐Ÿ“… 2006 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 474 KB

## Abstract An experiment has been done to measure the rise in temperature of a gas during filling a tank at high pressure. The experimental condition is that filling gases are nitrogen and hydrogen at a pressure of 5 to 35 MPa and at a filling mass of __G__=45 to 324 g/min for hydrogen. The temper

Effect of membrane characteristics on ma
โœ V.D Alves; I.M Coelhoso ๐Ÿ“‚ Article ๐Ÿ“… 2004 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 176 KB

The influence of the membrane characteristics on the water flux in the osmotic evaporation process, is evaluated. Due to the favourable hydrodynamic conditions used, concentration polarization was negligible. The effect of the membrane pore diameter, is evaluated, using symmetric membranes with the

Characteristics of transient heat transf
โœ Hiroaki Matsueda; Masanori Monde; Shoichi Matsuda ๐Ÿ“‚ Article ๐Ÿ“… 2007 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 1011 KB

## Abstract An experimental study has been conducted to elucidate characteristics of transient heat transfer during quenching of a vertical hot surface with a falling liquid film. The experiment was done at atmospheric pressure for the following conditions: an initial surface temperature from 200 t