✦ LIBER ✦

Generating Tool Paths for Free-Form Pocket Machining Using z-Buffer-Based Voronoi Diagrams

✍ Scribed by Jaehun Jeong; Kwangsoo Kim

Publisher: Springer
Year: 1999
Tongue: English
Weight: 304 KB
Volume: 15
Category: Article
ISSN: 0268-3768
DOI: 10.1007/s001700050055

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Tool path generation for machining free-

Tool path generation for machining free-form pockets using Voronoi diagrams

✍ J. Jeong; K. Kim 📂 Article 📅 1998 🏛 Springer 🌐 English ⚖ 579 KB

Tool path generation for machining free-

Tool path generation for machining free-form pockets with islands

✍ Kwangsoo Kim; Jaehun Jeong 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 430 KB

Generation of Tool Paths for Machining F

Generation of Tool Paths for Machining Free-Form Pockets with Islands Using Distance Maps

✍ J Jeong; K Kim 📂 Article 📅 1999 🏛 Springer 🌐 English ⚖ 256 KB

Voronoi diagram-based tool path compensa

Voronoi diagram-based tool path compensations for removing uncut material in 2½D pocket machining

✍ M. Salman A. Mansor; S. Hinduja; O.O. Owodunni 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 694 KB

This paper solves the problem of uncut areas, which can arise when 2 1 ⁄ 2 D pockets are machined with radial widths of cut greater than half the cutter diameter. Using the Voronoi diagram approach, three types of uncut areas are defined i.e., corner, centre and neck uncut regions. The corner uncut