𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Gelation studies of a cellulose-based biohydrogel: The influence of pH, temperature and sterilization

✍ Scribed by Ahmed Fatimi; Jean-François Tassin; Roman Turczyn; Monique A.V. Axelos; Pierre Weiss


Publisher
Elsevier Science
Year
2009
Tongue
English
Weight
642 KB
Volume
5
Category
Article
ISSN
1742-7061

No coin nor oath required. For personal study only.

✦ Synopsis


The present paper investigates the rheological properties of silated hydroxypropylmethylcellulose (Si-HPMC) biohydrogel used for biomaterials and tissue engineering applications. The general property of this modified cellulose ether is the occurrence of self-hardening due to silanol condensation subsequent to a decrease in pH (from 12.4 to nearly 7.4). The behavior of unsterilized and sterilized Si-HPMC solutions in diluted and concentrated domains is first described and compared. In addition, the influence of physiological parameters such as pH and temperature on the rate of the gelation process is studied. In dilute solution, the intrinsic viscosity ([eta]) of different pre-steam sterilization Si-HPMC solutions indicates that macromolecular chains occupy a larger hydrodynamic volume than the post-steam sterilization Si-HPMC solutions. Although the unsterilized Si-HPMC solutions demonstrate no detectable influence of pH upon the rheological behavior, a decrease in the limiting viscosities (eta(0)) of solutions with increasing pH is observed following steam sterilization. This effect can be explained by the formation of intra- and intermolecular associations during the sterilization stage originating from the temperature-induced phase separation. The formation of Si-HPMC hydrogels from injectable aqueous solution is studied after neutralization by different acid buffers leading to various final pHs. Gelation time (t(gel)) decreases when pH increases (t(gel) varies from 872 to 11s at pH 7.4 and 11.8, respectively). The same effect is observed by increasing the temperature from 20 to 45 degrees C. This is a consequence of the synergistic effect of the increased reaction rate and acid buffer diffusion. pH and temperature are important parameters in the gelation process and their influence is a key factor in controlling gelation time. By adapting the gel parameters one could propose hydrogels with cross-linking properties adapted to clinical applications by controlling the amount of pH of neutralization and temperature.


📜 SIMILAR VOLUMES


The influence of temperature, cholestero
✍ W.W. Sułkowski; D. Pentak; K. Nowak; A. Sułkowska 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 387 KB

The EPR and NMR spectroscopy was used to determine the influence of temperature (297-340 K), cholesterol and pH on liposome membranes obtained by modified reverse-phase method (mREV). For preparation of liposomes, L-a-phosphatidylcholine dipalmitoyl (DPPC) and 5-cholesten-3b-ol (cholesterol), main c

Influence of temperature and pH on the k
✍ Stijn WH Van Hulle; Eveline IP Volcke; Josefa López Teruel; Brecht Donckels; Mar 📂 Article 📅 2007 🏛 Wiley (John Wiley & Sons) 🌐 English ⚖ 222 KB 👁 1 views

## Abstract The SHARON (Single reactor High activity Ammonia Removal Over Nitrite) process is an innovative process that improves the sustainability of wastewater treatment, especially when combined with an Anammox process. It aims at ammonium oxidation to nitrite only, while preventing further nit

Influence of the hydrothermal temperatur
✍ K. Ozeki; H. Aoki; T. Masuzawa 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 443 KB

Hydroxyapatite (HA) was coated onto titanium substrates using radio frequency sputtering, and the sputtered films were crystallized under hydrothermal conditions at 110-170 • C at pH values of 7.0 and 9.5. The crystallite size, the remnant film thickness, and the surface morphology of the films were