𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Fuel elements for high temperature gas-cooled reactors

✍ Scribed by R.L. Hammer; J.M. Robbins; J.H. Coobs; J.L. Scott


Publisher
Elsevier Science
Year
1972
Tongue
English
Weight
142 KB
Volume
10
Category
Article
ISSN
0008-6223

No coin nor oath required. For personal study only.


πŸ“œ SIMILAR VOLUMES


Detection of gas-permeable fuel particle
✍ B.A. Thiele; D.P. Stinton; D.A. Costanzo πŸ“‚ Article πŸ“… 1980 πŸ› Elsevier Science 🌐 English βš– 771 KB

Fuel for High-Temperature Gas-Cooled Reactors (HTGR) consists of uranium oxide-carbide and thoria microspheres coated with layers of pyrolytic carbon and silicon carbide. The pyrolytic carbon coatings must be gastight to perform properly during irradiation. Therefore, particles must be carefully cha

96. Some aspects of carbon transport in
✍ M.R. Everett; D.V. Kinsey πŸ“‚ Article πŸ“… 1965 πŸ› Elsevier Science 🌐 English βš– 219 KB

dioxide and water vapor were determined in flowing helium at a total pressure of 1 atm. The rates were obtained from continuously recorded weight changes and from intermittent analyses of the effluent gases. The effect of temperature, flow rate, partial pressure of oxidant, and burnoff were examined

High temperature corrosion of structural
✍ C. Cabet; A. Terlain; P. Lett; L. GuΓ©taz; J.-M. Gentzbittel πŸ“‚ Article πŸ“… 2006 πŸ› John Wiley and Sons 🌐 German βš– 281 KB

## Abstract The Generation IV International Forum has selected six promising nuclear power systems for further collaborative investigations and development. Among these six concepts, two candidates are Gas Cooled Reactors (GCR), namely the Very High Temperature Reactor (VHTR) and the Gas‐cooled Fas

Performance of passive heat removal by a
✍ Shoji Takada; Kunihiko Suzuki; Yoshiyuki Inagaki; Yukio Sudo πŸ“‚ Article πŸ“… 2002 πŸ› John Wiley and Sons 🌐 English βš– 849 KB

## Abstract An experiment was performed to simulate an air‐cooling panel system for passive decay heat removal from a high‐temperature gas‐cooled reactor to investigate the performance of decay heat removal and the temperature distributions of components of the system. The experimental apparatus co