๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Forming characteristics of AZ31B magnesium alloy in bidirectional extrusion process

โœ Scribed by D.J. Yoon; S.J. Lim; H.G. Jeong; E.Z. Kim; C.D. Cho

Publisher
Elsevier Science
Year
2008
Tongue
English
Weight
857 KB
Volume
201
Category
Article
ISSN
0924-0136

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Cold stamping formability of AZ31B magne
Cold stamping formability of AZ31B magnesium alloy sheet undergoing repeated unidirectional bending process
โœ Lei Zhang; Guangsheng Huang; Hua Zhang; Bo Song ๐Ÿ“‚ Article ๐Ÿ“… 2011 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 516 KB

The repeated unidirectional bending (RUB) process was carried out on an AZ31B magnesium alloy in order to investigate its effects on the cold stamping formability. The limiting drawing ratio (LDR) of the RUB processed magnesium alloy sheet with an inclination of basal pole in the rolling direction c

Solidification of AZ31 magnesium alloy p
Solidification of AZ31 magnesium alloy plate in a horizontal continuous casting process
โœ Bong Sun You; Chang Dong Yim; Su Hyeon Kim ๐Ÿ“‚ Article ๐Ÿ“… 2005 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 948 KB

Magnesium plate of 120 mm width and 30 mm thickness was produced by horizontal continuous casting, and its microstructures were analyzed on the surface and in the plate interior. The defect formation on the surface and subsurface, such as side cracks, buckling, pores and segregation, was very sensit

Effect of pressurization profile on the
Effect of pressurization profile on the deformation characteristics of fine-grained AZ31B Mg alloy sheet during gas blow forming
โœ Pin-Hou Sun; Horng-Yu Wu; Hsin-Han Tsai; Chih-Chao Huang; Ming-Da Tzou ๐Ÿ“‚ Article ๐Ÿ“… 2010 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 505 KB

The deformation characteristics of a 0.6 mm-thick, fine-grained AZ31B Mg alloy sheet were investigated with the intention of reducing forming time during gas blow forming. The sheets were successfully deformed into hemispherical domes at 300, 370, and 420 โ€ข C under various pressurization profiles. T