๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Forming behaviour of some sheet steel materials when drawn through a conical die

โœ Scribed by R. Narayanasamy; R. Sowerby

Publisher
Elsevier Science
Year
1993
Tongue
English
Weight
427 KB
Volume
39
Category
Article
ISSN
0924-0136

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Wrinkling behaviour of interstitial free
Wrinkling behaviour of interstitial free steel sheets when drawn through tapered dies
โœ R. Narayanasamy; C. Sathiya Narayanan ๐Ÿ“‚ Article ๐Ÿ“… 2007 ๐Ÿ› Elsevier Science โš– 331 KB

Wrinkling is a mode of failure commonly observed in the forming of sheet metals during deep draw operation. An experimental study on wrinkling behaviour of interstitial free (IF) steels through conical and tractrix dies is discussed in this paper. Mechanical properties and drawability parameters of

Wrinkling of sheet metals when drawing t
Wrinkling of sheet metals when drawing through a conical die
โœ R. Narayanasamy; R. Sowerby ๐Ÿ“‚ Article ๐Ÿ“… 1994 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 656 KB

This paper deals with the deep drawing of circular blanks into cylindrical cups through a conical die using flat-bottomed and hemispherical-ended punches. It is well established that the use of a conical die can enhance the limiting drawing ratio compared with that obtainable in a conventional drawi

Wrinkling behaviour of cold-rolled sheet
Wrinkling behaviour of cold-rolled sheet metals when drawing through a tractrix die
โœ R. Narayanasamy; R. Sowerby ๐Ÿ“‚ Article ๐Ÿ“… 1995 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 462 KB

This paper deals with the deep drawing of circular blanks into cylindrical cups through a Tractrix die using flat-bottomed and hemispherically-ended punches. It is well established that the use of a Tractrix die can enhance the limiting draw ratio as compared with that obtainable in a conventional d