✦ LIBER ✦

Flow over convergent and divergent wall riblets

✍ Scribed by K. Koeltzsch; A. Dinkelacker; R. Grundmann

Book ID: 106036328
Publisher: Springer
Year: 2002
Tongue: English
Weight: 206 KB
Volume: 33
Category: Article
ISSN: 0723-4864
DOI: 10.1007/s00348-002-0446-3

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Modelling the time-dependent flow over r

Modelling the time-dependent flow over riblets in the viscous wall region

✍ Tullis, S. ;Pollard, A. 📂 Article 📅 1993 🏛 Springer 🌐 English ⚖ 588 KB

Slip flow in converging and diverging ch

Slip flow in converging and diverging channels

✍ J. M. Dorrepaal 📂 Article 📅 1993 🏛 Springer 🌐 English ⚖ 688 KB

The classical problem of Jeffery-Hamel flow is considered in which the fluid is allowed to slip along the walls of the channel. The problem is solved analytically and the volumetric flow rate is computed and compared with that of the corresponding no-slip flow. In the converging channel case, it is

Converging and diverging flow in narrow

Converging and diverging flow in narrow conical passages

✍ G. H. Vatistas; W. S. Ghaly 📂 Article 📅 1999 🏛 Springer Vienna 🌐 English ⚖ 686 KB

Slow laminar flow in a converging or div

Slow laminar flow in a converging or diverging channel with suction at one wall and blowing at the other wall

✍ Robert M. Terrill 📂 Article 📅 1965 🏛 Springer 🌐 English ⚖ 149 KB

Heat transfer and pressure drop characte

Heat transfer and pressure drop characteristics of flow in convergent and divergent ducts

✍ Chin-Chia Su; Huang Lin 📂 Article 📅 1991 🏛 John Wiley and Sons 🌐 English ⚖ 561 KB

EXPERIMENTAL STUDIES ON FLOW IN CONVERGE

EXPERIMENTAL STUDIES ON FLOW IN CONVERGENT AND DIVERGENT DUCTS OF RECTANGULAR CROSS SECTION

✍ Chin-Chia Su; Ray-Hong Lin 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 211 KB 👁 2 views

This paper describes the experimental examination of the pressure drop and heat transfer of the flow in convergent and divergent ducts of rectangular cross section. The aspect ratio based on the dimensions of the large end of the duct was 0•1. It has been found that at a given convergent or divergen