Flow-injection analysis for aluminium with indirect amperometric detection
β Scribed by Alison J. Downard; H.Kipton J. Powell; Shuanghua Xu
- Publisher
- Elsevier Science
- Year
- 1992
- Tongue
- English
- Weight
- 551 KB
- Volume
- 256
- Category
- Article
- ISSN
- 0003-2670
No coin nor oath required. For personal study only.
β¦ Synopsis
Alummmm was determined m a flow-llyection system mvolvmg the formation of the alummmmUII)-l,Zdihydroxyanthraqumone-3-sulphomc acid (DASA) complex at pH 9 0 and amperometrlc measurement of excess of DASA at +0 50 V on a gold electrode Electrode fouhng by adsorption of DASA oxldatlon products was mmumzed by use of a double pumpmg system to provide a reagent cycle and a wash cycle During the wash cycle the gold electrode surface was reactivated electrochemically by cathodic-anodic voltage cychng The hnear workmg range was governed by the DASA concentration For 2 x 10e5, 5 x 10m5 and 5 x 10e4 M DASA the hnear ranges were (0 05-l 0) X lo-', (0 l-2 2) x 10e5 and (0 l-l 2) X 10e4 M Al(III), respectwely
The detectIon hnut when using 2 X 10m5 M DASA was 2 5 x 10e7 M Al(III) and the R S D for 9 x 10W6 M Al(W) was 4 3% (n = 6) Nitnlotnacetic aad, tannins and Fe(III) interfered, no interference was observed with F-, PO:-, citnc, oxalic and fulvrc acids, Mg2+ or Ca2+ The method was applied to the determmation of Al(II1) m soil extracts
π SIMILAR VOLUMES
The change in peak current resulting from the reaction of Fe(I1) with nitroso-R salt in a flow-injection system is used to quantify Fe(I1) with either single-or dual-electrode amperometric detectors. The current change varies linearly with Fe(I1) concentration from 0 to 200 mg 1-l. The relative stan
A dual-electrode voltammetric/amperometric detector for flow-injection systems is described. The detector provides qualitative voltammetric information without the charging currents associated with scanning the potential. Selectivity is enhanced relative to direct voltammetric detection at a single
Flow injection analysis (FIA) with amperometric detection is applied to the determination of cocaine. Flow parameters were optimised prior to electrode calibration: a detection potential of +l V vs. Ag/AgCYsat. KC1 and a flow rate of 2.5 ml min-' resulted adequate. A relative standard deviation of 1