✦ LIBER ✦

Flat-end cutter path generation for a sculptured surface for 3-axes NC machining

✍ Scribed by Daoyuan Yu; Zhengcheng Duan; Wei Zhang; Jinning Liu

Publisher: Elsevier Science
Year: 1996
Tongue: English
Weight: 385 KB
Volume: 57
Category: Article
ISSN: 0924-0136
DOI: 10.1016/0924-0136(95)02048-9

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Efficient cutter-path planning for five-

Efficient cutter-path planning for five-axis surface machining with a flat-end cutter

✍ C-C Lo 📂 Article 📅 1999 🏛 Elsevier Science 🌐 English ⚖ 517 KB

This paper presents a method to improve the machining efficiency for 5-axis surface machining with a flat-end cutter. In the proposed method, the cutter paths are scheduled so that the scallop height formed by two adjacent machining paths is maintained constant. Along each machining path, the inclin

Rough and finish tool-path generation fo

Rough and finish tool-path generation for NC machining of freeform surfaces based on a multiresolution method

✍ Z. Yin 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 283 KB

Progressive fitting and multiresolution tool path generating techniques are proposed in this paper, by which multi-level (LOD) models fitting for different subsets of sampled points are obtained, and then multiresolution rough-cut and finish-cut tool paths are generated based on the LOD models. The