✦ LIBER ✦

Flange/web distortional buckling of cold-formed steel sections in bending

✍ Scribed by C.A. Rogers; R.M. Schuster

Publisher: Elsevier Science
Year: 1997
Tongue: English
Weight: 726 KB
Volume: 27
Category: Article
ISSN: 0263-8231
DOI: 10.1016/0263-8231(96)00017-1

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Analysis for local buckling capacity of

Analysis for local buckling capacity of cold-formed steel sections with web opening

✍ K.S. Sivakumaran 📂 Article 📅 1987 🏛 Elsevier Science 🌐 English ⚖ 726 KB

A new formulation for distortional buckl

A new formulation for distortional buckling stress in cold-formed steel members

✍ Murat Pala 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 512 KB

Distortional buckling of compression members usually comprises rotation and translation of each flange and lip about the flange-web connection in opposite directions. The present procedures for the calculation of elastic distortional buckling stress in the literature are very complex, cumbersome and

Yield line mechanism analysis on web cri

Yield line mechanism analysis on web crippling of cold-formed stainless steel tubular sections under two-flange loading

✍ Feng Zhou; Ben Young 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 824 KB

The yield line mechanism analysis on web crippling of cold-formed stainless steel square and rectangular hollow sections under two-flange loading is presented in this paper. A concentrated load was applied by means of bearing plates which act across the full flange width of the sections. Two-flange

The design of bolted joints in cold-form

The design of bolted joints in cold-formed steel sections

✍ E.R. Bryan 📂 Article 📅 1993 🏛 Elsevier Science 🌐 English ⚖ 858 KB