𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Finite element study of a workpiece in a machining fixture

✍ Scribed by D.T. Pham; A. de Sam Lazaro

Publisher
Elsevier Science
Year
1990
Tongue
English
Weight
446 KB
Volume
14
Category
Article
ISSN
0895-7177

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

The influence of support conditions in t
The influence of support conditions in the loading fixture on failure mechanisms in the push-out test: A finite element study
✍ Dr. T. P. Harrigan; J. Kareh; W. H. Harris πŸ“‚ Article πŸ“… 1990 πŸ› Elsevier Science 🌐 English βš– 647 KB

## Abstract The usefulness of the push‐out test as an indicator of interface strength was evaluated using finite element models of intact and partially failed cylindrical push‐out specimens loaded against a rigid annular support. The irregular stress distributions that were found in intact specimen

A model to predict minimum required clam
A model to predict minimum required clamp pre-loads in light of fixture–workpiece compliance
✍ Edward C. De Meter; Wei Xie; Shabbir Choudhuri; Subramanian Vallapuzha; Martin W πŸ“‚ Article πŸ“… 2001 πŸ› Elsevier Science 🌐 English βš– 588 KB

The determination of minimum required clamp pre-loads is an important process in the design of machining fixtures. This paper presents a linear, clamp pre-load (LCPL) model that can be applied to fixtureworkpiece systems whose compliance is load invariant. The model considers the static deformation