✦ LIBER ✦

Finite Element Simulation of Cutting Forces in Orthogonal Machining of Titanium Alloy Ti-6Al-4V

✍ Scribed by Kandráč, Ladislav; Maňková, Ildikó; Vrabel', Marek; Beňo, Jozef

Book ID: 126910641
Publisher: Trans Tech Publications Inc.
Year: 2014
Tongue: English
Weight: 313 KB
Volume: 474
Category: Article
ISSN: 1660-9336
DOI: 10.4028/www.scientific.net/amm.474.192

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Simulation machining of titanium alloy (

Simulation machining of titanium alloy (Ti-6Al-4V) based on the finite element modeling

✍ Ali, Moaz H.; Ansari, M. N. M.; Khidhir, Basim A.; Mohamed, Bashir; Oshkour, A. 📂 Article 📅 2013 🏛 SciELO 🌐 English ⚖ 849 KB

Finite element simulation of machining o

Finite element simulation of machining of Ti-6Al-4V alloy with thermodynamical constitutive equation

✍ Fang Shao; Zhanqiang Liu; Yi Wan; Zhenyu Shi 📂 Article 📅 2009 🏛 Springer 🌐 English ⚖ 551 KB

Finite element simulation of high-speed

Finite element simulation of high-speed machining of titanium alloy (Ti–6Al–4V) based on ductile failure model

✍ Guang Chen; Chengzu Ren; Xiaoyong Yang; Xinmin Jin; Tao Guo 📂 Article 📅 2011 🏛 Springer 🌐 English ⚖ 933 KB

Dynamics of chip formation during orthog

Dynamics of chip formation during orthogonal cutting of titanium alloy Ti–6Al–4V

✍ M. Cotterell; G. Byrne 📂 Article 📅 2008 🏛 International Academy for Production Engineering 🌐 English ⚖ 828 KB

Characterisation of chip formation durin

Characterisation of chip formation during orthogonal cutting of titanium alloy Ti–6Al–4V

✍ Matthew Cotterell; Gerry Byrne 📂 Article 📅 2008 🏛 Elsevier 🌐 English ⚖ 846 KB

Friction and cutting forces in cryogenic

Friction and cutting forces in cryogenic machining of Ti–6Al–4V

✍ Shane Y Hong; Yucheng Ding; Woo-cheol Jeong 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 325 KB

Conventional cutting fluid serves both as a coolant and lubricant. In cryogenic machining, liquid nitrogen (LN2) is recognized as an effective coolant due to its low temperature; however, its lubrication properties are not well known. The focus of this study was to investigate how the friction betwe