✦ LIBER ✦

Finite element modeling and failure prediction of friction stir welded blanks

✍ Scribed by Amir Abbas Zadpoor; Jos Sinke; Rinze Benedictus

Publisher: Elsevier Science
Year: 2009
Weight: 696 KB
Volume: 30
Category: Article
ISSN: 0261-3069
DOI: 10.1016/j.matdes.2008.08.018

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Predicting tensile strength of friction

Predicting tensile strength of friction stir welded AA6061 aluminium alloy joints by a mathematical model

✍ K. Elangovan; V. Balasubramanian; S. Babu 📂 Article 📅 2009 🏛 Elsevier Science ⚖ 580 KB

AA6061 aluminium alloy (Al-Mg-Si alloy) has gathered wide acceptance in the fabrication of light weight structures requiring a high strength-to weight ratio and good corrosion resistance. Compared to the fusion welding processes that are routinely used for joining structural aluminium alloys, fricti

Finite element modelling of wooden struc

Finite element modelling of wooden structures at large deformations and brittle failure prediction

✍ M. Oudjene; M. Khelifa 📂 Article 📅 2009 🏛 Elsevier Science ⚖ 537 KB

Finite element modeling of equal channel

Finite element modeling of equal channel angular pressing: Effect of material properties, friction and die geometry

✍ S. Dumoulin; H.J. Roven; J.C. Werenskiold; H.S. Valberg 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 170 KB

Numerous analytical and numerical studies on equal channel angular pressing have been performed in recent years. The present work focuses on the effects of friction, initial material properties and die geometry and aims at enhancing the understanding of these effects on strain homogeneity and mean e

Low-cycle fatigue life prediction of spo

Low-cycle fatigue life prediction of spot welds based on hardness distribution and finite element analysis

✍ Rui-Jie Wang; De-Guang Shang 📂 Article 📅 2009 🏛 Elsevier Science 🌐 English ⚖ 484 KB

Elasto-plastic finite element analysis was carried out for single spot tensile shear spot welds with software ANSYS. According to the relationship between micro-hardness and strength, cyclic material constants of different zones in the periphery of spot welds were determined in accordance with hardn

Sequential modeling of local precipitati

Sequential modeling of local precipitation, strength and strain hardening in friction stir welds of an aluminum alloy 6005A-T6

✍ A. Simar; Y. Bréchet; B. de Meester; A. Denquin; T. Pardoen 📂 Article 📅 2007 🏛 Elsevier Science 🌐 English ⚖ 659 KB

A novel microstructure-based strain-hardening model for precipitate hardening materials is developed, accounting, in addition to the usual contributions, for the influence of a supersaturated solid solution as well as for a dependence of dynamic recovery on the yield strength and on the presence and

Influence of local friction coefficient

Influence of local friction coefficient and strain hardening on the scratch resistance of polymeric surfaces investigated by finite element modeling

✍ H. Pelletier; J. Krier; C. Gauthier 📂 Article 📅 2011 🏛 Elsevier 🌐 English ⚖ 401 KB

In this study, we propose the mechanical analysis of contact between a rigid spherical indenter and an amorphous polymeric surface during scratching. Experimental scratch tests, using our specific experimental set-up, allowing in situ observation of the contact area and also of the residual groove,