Fibers from a low dielectric constant fluorinated polyimide: Solution spinning and morphology control
✍ Scribed by Mark Eashoo; Leonard J. Buckley; Anne K. St. Clair
- Publisher
- John Wiley and Sons
- Year
- 1997
- Tongue
- English
- Weight
- 522 KB
- Volume
- 35
- Category
- Article
- ISSN
- 0887-6266
No coin nor oath required. For personal study only.
✦ Synopsis
SYNOPSIS
Control of the internal morphology of wet-spun fibers from a fluorinated polyimide has been achieved by varying the rate of polymer coagulation through adjustments in nonsolvent/solvent miscibility and precipitation strength of the coagulation bath. Filament internal morphologies ranged from very porous or sponge-like to fully solid. Intermediate structures included fibers containing a spongy core with a nonporous skin, sponge-like fibers containing large voids, and a relatively solid material containing randomly spaced small voids. The cross-sectional shape of the fiber is dependent upon the coagulation process as well as the volume contraction of the initial extrudate. Drawn fibers (31) retained the original as-spun cross-sectional shape and also lost porosity. Mechanical properties of poly(6FDA-4BDAF) fibers have an inverse relationship to filament porosity. Maximum modulus and break strength for drawn fibers is approximately 6 GPa and 200 MPa, respectively. As-spun mechanical properties were dependent upon the processing conditions and have moduli between 0.4-3.0 GPa and break strengths of 10-160 MPa. A dielectric constant of 2.50 for nonporous films was measured over a frequency range between 1.0 MHz to 1.8 GHz, showing little dispersion.