๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Fatigue design of welded aluminum rectangular hollow section joints

โœ Scribed by K.a. Macdonald; P.J. Haagensen

Publisher
Elsevier Science
Year
1999
Tongue
English
Weight
477 KB
Volume
6
Category
Article
ISSN
1350-6307

No coin nor oath required. For personal study only.

๐Ÿ“œ SIMILAR VOLUMES

Discussion on local approaches for the f
Discussion on local approaches for the fatigue design of welded joints
โœ C. Casavola; C. Pappalettere ๐Ÿ“‚ Article ๐Ÿ“… 2009 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 912 KB

Design of welded structures under fatigue is governed by two conflicting requirements: to minimize weight without compromising structure safety. Any theoretical and/or numerical approaches are necessarily based on some simplifying assumptions which, because of the complexity of fatigue phenomena, co

Behaviour of welded T-end connection to
Behaviour of welded T-end connection to rectangular hollow section (RHS) in axial tension
โœ M. Saidani ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 873 KB

This paper presents the results of an experimental investigation of the behaviour of T-end connections welded to rectangular hollow section (RHS) members subjected to axial tension. A total of 19 specimens were tested to failure. Parameters considered for the investigation were the tube size and the

Evaluation of fatigue strength of fricti
Evaluation of fatigue strength of friction stir butt-welded aluminum alloy joints inclined to applied cyclic stress
โœ Shigenobu Kainuma; Hiroto Katsuki; Ichiro Iwai; Masaki Kumagai ๐Ÿ“‚ Article ๐Ÿ“… 2008 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 839 KB

Recently, fatigue tests have been performed to investigate the fatigue behavior of friction stir butt-welded aluminum alloy joints. However, the joints of more than 10 mm thick plates have rarely been tested, nor has the effect of the inclined angle of the friction stir welding line to the applied s