✦ LIBER ✦

Fatigue-crack propagation in high yield-strength steels

✍ Scribed by J.M. Barsom; E.J. Imhof; S.T. Rolfe

Publisher: Elsevier Science
Year: 1971
Tongue: English
Weight: 987 KB
Volume: 2
Category: Article
ISSN: 0013-7944
DOI: 10.1016/0013-7944(71)90016-6

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Mechanism of corrosion fatigue crack pro

Mechanism of corrosion fatigue crack propagation in high strength steels

✍ Nakasa Keijiro; Takei Hideo; Itoh Hisashi 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 922 KB

The crack propagation velocity in corroGon fatigue (du/dN), were measured on the Ni-Cr-Mo steel quenched and tempered at 473 or 773 K. The steel with high sensitivity to delayed failure reveals the largest (du/dN), under square load and the smaller (da/dN), under positive saw tooth load. The frequen

Near-threshold fatigue crack propagation

Near-threshold fatigue crack propagation of several high strength steels

✍ T.L. Mackay; B.J. Alperin; D.D. Bhatt 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 704 KB

In support of Douglas Aircraft Co. structural damage tolerance analysis, crack propagation rates were measured in humid air from lo-\* to 10m3 mm/cycle of several high strength martensitic steels at stress ratios of R = 0.1 and R = 0.5. Increasing the stress ratio was found to decrease the threshold

Fatigue crack propagation in steels

✍ Zheng Xiulin; Manfred A. Hirt 📂 Article 📅 1983 🏛 Elsevier Science 🌐 English ⚖ 832 KB

From previous investigations of the mechanisms of both fracture and fatigue crack propagation, the static fracture model proposed by Lal and Weiss may be thought as reasonable for describing fatigue crack propagation in metals at both low and interm~iate stress intensity factor ranges AK. Recent pro

Crack nucleation and propagation of corr

Crack nucleation and propagation of corrosion fatigue in high-strength steel

✍ Y Hirose; T Mura 📂 Article 📅 1985 🏛 Elsevier Science 🌐 English ⚖ 851 KB

Crack nucleation and growth behavior of corrosion fatigue are investigated experimentally and theoretically for 200°C tempered AISI 4340 steel in 35% NaCl solution. The crack nucleation at notch roots is determined by the electrical potential method. The cycle for crack nucleation, N,, increases wit

Fatigue crack propagation in austenitic

Fatigue crack propagation in austenitic stainless steels

✍ Anthony W. Thompson 📂 Article 📅 1975 🏛 Elsevier Science 🌐 English ⚖ 820 KB

## AMraet-Fatigue crack growth rate was found to be independent of grain size in 309!3 stainless steel, for grain sizes of 45 and 480 pm. The data were compared to literature results for a variety of stabk and mtstabie austerdtic alloys, and were shown to agree well, THE RECENT literature on fatig

Fatigue crack propagation in mild steel

✍ C.L. Chow; C.W. Woo; K.T. Chung 📂 Article 📅 1986 🏛 Elsevier Science 🌐 English ⚖ 572 KB