Fatigue crack propagation behavior of ultra high molecular weight polyethylene under mixed mode conditions

✍ Scribed by Elbert, K. E. ;Wright, T. M. ;Rimnac, C. M. ;Klein, R. W. ;Ingraffea, A. R. ;Gunsallus, K. ;Bartel, D. L.

• Publisher: John Wiley and Sons
• Year: 1994
• Tongue: English
• Weight: 609 KB
• Volume: 28
• Category: Article
• ISSN: 0021-9304
• DOI: 10.1002/jbm.820280207

✦ Synopsis

Abstract

Analytical studies of the stresses on and within ultra high molecular weight polyethylene joint components suggest that damage modes associated with polyethylene fatigue failure are caused by a combination of surface and subsurface crack propagation. Fatigue crack propagation tests under mixed mode loading conditions were conducted on center‐cracked tension specimens machined from extruded blocks of sterilized polyethylene in an attempt to determine how fatigue cracks change direction in this material. Cyclic testing was performed using a sinusoidal wave form at a frequency of 5 Hz and an R‐ratio (minimum load/ maximum load) of 0.15. Specimens had the notch oriented perpendicular to the direction of applied load and at angles of 60° and 45° to the loading direction. Numerical analyses were used to interpret the experimental test and to predict the fatigue behavior of polyethylene under mixed mode conditions. It was found that all cracks eventually propagated horizontally, regardless of the initial angle of inclination of the notch to the direction of applied cyclic load. In fact, the extent of the curvilinear crack growth was quite limited. An effective range of cyclic stress intensity factor was calculated for correlation with the rate of crack growth. The results followed a Paris relation, with crack growth rate linearly related to a power of the range of stress intensity, for all three crack orientations. The numerical analyses adequately modeled the experimental fatigue crack growth results. © 1994 John Wiley & Sons, Inc.