✦ LIBER ✦

Fatigue crack growth tests on type 321 austenitic stainless steel in corrosive environment and at elevated temperature

✍ Scribed by János Lukács

Book ID: 108255648
Publisher: Elsevier
Year: 2010
Tongue: English
Weight: 889 KB
Volume: 2
Category: Article
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2010.03.130

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Crack closure and influence of cycle rat

Crack closure and influence of cycle ratio R on fatigue crack growth in type 304 stainless steel at room temperature

✍ H.U Staal; J.D Elen 📂 Article 📅 1979 🏛 Elsevier Science 🌐 English ⚖ 775 KB

Crack growth rate and crack closure during fatigue of type 304 stainless steel are measured with an optical microscope and television camera. Based on the crack closure data an effective stress intensity range AKFR is calculated. The da/da vs A&-curves indicate that crack closure could account for t

Fatigue strength of low-carbon and auste

Fatigue strength of low-carbon and austenitic stainless steels in low-cycle torsion tests in caustic and chloride solutions at elevated temperatures

✍ N. N. Tkachenko; I. Yu. Liskevich; R. P. Svistun 📂 Article 📅 1975 🏛 Springer 🌐 English ⚖ 219 KB

Fatigue crack growth in 316 type stainle

Fatigue crack growth in 316 type stainless steel at temperatures and displacement damage rates representative for the first wall loading

✍ P. Fenici; Shi Suolang 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 304 KB

Creep-fatigue crack growth and fractogra

Creep-fatigue crack growth and fractography of a Type 304 stainless steel at elevated temperature: Koterazawa, R. and Nosho, T. Fatigue Fract. Eng. Mater. Struct. 1991 14 (1), 1–9

📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 175 KB

Fatigue behaviour of stainless steels un

Fatigue behaviour of stainless steels under simultaneous corrosion attack: I. Behaviour at elevated temperatures and in hot gas environment : Roeder, E. and Schumacher, G.Steel Res. 1989 60, (8), 375–382 (in German)

📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 175 KB

Effect of preliminary surface working on

Effect of preliminary surface working on fatigue strength of type 304 stainless steel at ambient temperature and 288 °C in air and pure water environment

✍ Makoto Hayashi; Kunio Enomoto 📂 Article 📅 2006 🏛 Elsevier Science 🌐 English ⚖ 564 KB

Effect of preliminary surface working on the fatigue strength of type 304 stainless steel in air and pure water at ambient temperature and 288 °C was examined. The surface finishings were electro-polishing, emery paper polishing, shot peening, shot peening followed by emery paper polishing, and glas