✦ LIBER ✦

Fabrication and measurement of a compact meander-line-type microstrip patch antenna with shorting pin for the 5-GHz band

✍ Scribed by Joong Han Yoon

Publisher: John Wiley and Sons
Year: 2006
Tongue: English
Weight: 147 KB
Volume: 48
Category: Article
ISSN: 0895-2477
DOI: 10.1002/mop.21527

No coin nor oath required. For personal study only.

✦ Synopsis

Abstract

This paper investigates the characteristics of the modified meander‐line‐type patch antenna for the 5‐GHz band. Its design was based on a modified meander line width and shorting pin with coaxial feeding. Its maximum measured impedance bandwidth (−10 dB and below) reaches approximately 1.64 GHz (4.765–6.405 GHz). Radiation patterns at different frequencies are also discussed, and the measured gains are about 5.74 to 9.09 dBi. © 2006 Wiley Periodicals, Inc. Microwave Opt Technol Lett 48: 944–947, 2006; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.21527

📜 SIMILAR VOLUMES

Design of a modified meander-type micros

Design of a modified meander-type microstrip patch antenna in the 5-GHZ band

✍ Joong-Han Yoon; Gyey-Teak Jeong; Moon-Kyou Kang; Hwa Choon Lee; Kyung-Sup Kwak 📂 Article 📅 2003 🏛 John Wiley and Sons 🌐 English ⚖ 199 KB

## Abstract In this paper, the characteristics of a modified meander‐type antenna for broadband impedance bandwidth are investigated in the 5‐GHz band. The design is based on a modified meander‐line width in a finite‐sized ground with coaxial SMA feeding. The modified meander‐type microstrip patch

Design of a dual-band π-shaped microstri

Design of a dual-band π-shaped microstrip patch antenna with a shorting pin for 5.2/5.8 GHz WLAN systems

✍ Sun-Ho Choi; Daehan Kwak; Hwa-Choon Lee; Kyung-Sup Kwak 📂 Article 📅 2010 🏛 John Wiley and Sons 🌐 English ⚖ 173 KB

## Abstract This article describes the design, fabrication, and measurement of a novel π‐shaped dual‐band antenna with a shorting pin for 5.2/5.8 GHz wireless local area network (WLAN) systems.To obtain sufficient bandwidth when return loss (RL) < −10 dB, a shorting pin is inserted in the patch and