๐”– Bobbio Scriptorium
โœฆ   LIBER   โœฆ

Fabrication and evaluation of small coils using PbMo6S8 wires

โœ Scribed by Y. Kubo; F. Uchikawa; S. Utsunomiya; K. Noto; K. Katagiri; N. Kobayashi


Publisher
Elsevier Science
Year
1993
Tongue
English
Weight
648 KB
Volume
33
Category
Article
ISSN
0011-2275

No coin nor oath required. For personal study only.

โœฆ Synopsis


Small three-layer coils with two kinds of mandrels (AI203 and MgO) were fabricated using Chevrel-phase PbMo6S e (PMS) superconducting wires prepared by a powder process. Jc evaluations were carried out on these coils. An excellentJ c of 3.0 x 104 A cm -2 at B = 12 T was obtained for the coil with a MgO mandrel, which corresponded to 84% of the best Jo for the same short wire. In the case of the AI20 3 mandrel, the Jc was degraded to 60% of this value. The thermal expansion coefficient and/c-Strain property of the PMS wires were also determined. The Jc degradation of the coils due to the tensile strain induced in the wire by the mandrels during the cooling process was estimated. As a consequence, the origin of Jc degradation for the small coils was found to be the strain applied from mandrels during the cooling process.


๐Ÿ“œ SIMILAR VOLUMES


Influence of transverse compressive and
โœ W. Goldacker; W. Specking; F. Weiss; G. Rimikis; R. Flรผkiger ๐Ÿ“‚ Article ๐Ÿ“… 1989 ๐Ÿ› Elsevier Science ๐ŸŒ English โš– 653 KB

The behaviour of the critical current density, Jc, of PbMo6Ss and SnMo6S8 monofilamentary wires with external transverse compressive stress, at, and axial tensile stress, aa, was investigated. Varying the reinforcing steel content in the wire matrix, different axial prestress states, e.g. the compre

Evaluation of internal MRI coils using u
โœ Haydar ร‡elik; Yiวงitcan Eryaman; Ayhan AltฤฑntaลŸ; I.A. Abdel-Hafez; Ergin Atalar ๐Ÿ“‚ Article ๐Ÿ“… 2004 ๐Ÿ› John Wiley and Sons ๐ŸŒ English โš– 455 KB

## Abstract The upper bounds of the signalโ€toโ€noise ratio (also known as the โ€œultimate intrinsic signalโ€toโ€noise ratioโ€ (UISNR)) for internal and external coils were calculated. In the calculation, the body was modeled as a dielectric cylinder with a small coaxial cylindrical cavity in which intern