✦ LIBER ✦

Extruding bimetal tubes

✍ Scribed by M. I. Chepurko; A. M. Buinovskii; L. S. Amelina; O. P. Drobich; L. S. Mikhal'chuk; L. N. Okhramovich; R. G. Mishchenko; L. I. Makhno

Book ID: 112392278
Publisher: Springer US
Year: 1968
Tongue: English
Weight: 618 KB
Volume: 12
Category: Article
ISSN: 0026-0894
DOI: 10.1007/bf00739935

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Extruded tubing

✍ Jones, David 📂 Article 📅 1998 🏛 Nature Publishing Group 🌐 English ⚖ 397 KB

Welding copper-silver bimetal tubing

✍ A. F. Batakshev; S. N. Berezhnitskii; N. V. Beislyam 📂 Article 📅 1981 🏛 Springer 🌐 English ⚖ 302 KB

Residual stresses occurring in bimetal t

Residual stresses occurring in bimetal tubes after thermal cycling

✍ P. I. Ermakov; V. A. Bashchuk; A. S. Nesmeyanov 📂 Article 📅 1976 🏛 Springer 🌐 English ⚖ 278 KB

Brittle behavior in extruded beryllium t

Brittle behavior in extruded beryllium tubes

✍ G. Sumner 📂 Article 📅 1966 🏛 Springer Netherlands 🌐 English ⚖ 801 KB

An investigation of brittle fracture in extruded beryllium tubes is described following an unusual brittle fracture of a beryllium clad fuel element at plastic strain of about 0.15% produced by differential thermal contraction. A characteristic spiral form of fracture is shown to be caused by cleava

Development of clad boiler tubes extrude

Development of clad boiler tubes extruded from bimetallic centrifugal castings

✍ D. L. Sponseller; G. A. Timmons; W. T. Bakker 📂 Article 📅 1998 🏛 Springer US 🌐 English ⚖ 288 KB

On bend-stretch forming of aluminum extr

On bend-stretch forming of aluminum extruded tubes — II: analysis

✍ J.E. Miller; S. Kyriakides; E. Corona 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 574 KB

Part II describes a two-dimensional model of the bend-stretch-pressure forming process, which assumes that the tube shape and all applied loads are uniform along the length. This simpli"cation results in a signi"cant improvement in computational time over corresponding three-dimensional models. The