✦ LIBER ✦

Experimental Study on Tool Wear when Machining Super Titanium Alloys: Ti6Al4V and Ti-555

✍ Scribed by Nouari, Mohammed; Makich, Hamid

Book ID: 121649975
Publisher: Trans Tech Publications, Ltd.
Year: 2013
Tongue: English
Weight: 937 KB
Volume: 763
Category: Article
ISSN: 1662-9752
DOI: 10.4028/www.scientific.net/MSF.763.51

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Tool wear prediction of machining hydrog

Tool wear prediction of machining hydrogenated titanium alloy Ti6Al4V with uncoated carbide tools

✍ Shubao Yang, Guohui Zhu, Jiuhua Xu, Yucan Fu 📂 Article 📅 2013 🏛 Springer 🌐 English ⚖ 917 KB

Experimental study of friction and wear

Experimental study of friction and wear characteristics of titanium alloy (Ti-6Al-4V) under lubricated sliding condition

✍ Dutt Sharma, Mukund; Sehgal, Rakesh 📂 Article 📅 2014 🏛 Emerald Group Publishing Limited 🌐 English ⚖ 380 KB

Study on Tool Wear and Chip Formation Du

Study on Tool Wear and Chip Formation During Drilling Carbon Fiber Reinforced Polymer (CFRP)/Titanium Alloy (Ti6Al4V) Stacks

✍ SenthilKumar, M.; Prabukarthi, A.; Krishnaraj, V. 📂 Article 📅 2013 🏛 Elsevier 🌐 English ⚖ 860 KB

Investigation on diffusion wear during h

Investigation on diffusion wear during high-speed machining Ti-6Al-4V alloy with straight tungsten carbide tools

✍ S. Zhang; J. F. Li; J. X. Deng; Y. S. Li 📂 Article 📅 2008 🏛 Springer 🌐 English ⚖ 370 KB

New cooling approach and tool life impro

New cooling approach and tool life improvement in cryogenic machining of titanium alloy Ti-6Al-4V

✍ Shane Y Hong; Irel Markus; Woo-cheol Jeong 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 393 KB

Titanium alloy Ti-6Al-4V, a difficult-to-machine material because of its extremely short tool life, has been a major subject for cryogenic machining research. However, the approaches reported in past publications are inherently flawed. This study reviews how the temperature affects Ti-6Al-4V propert

Investigations on Mechanisms of Tool Wea

Investigations on Mechanisms of Tool Wear in Machining of Ti-6Al-4V Using FEM Simulation

✍ Zanger, F.; Schulze, V. 📂 Article 📅 2013 🏛 Elsevier 🌐 English ⚖ 460 KB