✦ LIBER ✦

Experimental study on the effects of adding compression to injection molding process

✍ Scribed by S. Y. Yang; M. Z. Ke

Publisher: John Wiley and Sons
Year: 1995
Tongue: English
Weight: 762 KB
Volume: 14
Category: Article
ISSN: 0730-6679
DOI: 10.1002/adv.1995.060140102

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Simulation of injection-compression mold

Simulation of injection-compression molding process, Part 3: Effect of process conditions on part birefringence

✍ Shia-Chung Chen; Yung-Cheng Chen; Hsin-Shu Peng; Lei-Ti Huang 📂 Article 📅 2002 🏛 John Wiley and Sons 🌐 English ⚖ 341 KB 👁 2 views

Compression process effects on filling d

Compression process effects on filling density and replication properties of micro-surfaces during metal injection molding

✍ Kenji Okubo; Shigeo Tanaka; Hiroyuki Hamada; Hiroshi Ito 📂 Article 📅 2009 🏛 Wiley (John Wiley & Sons) 🌐 English ⚖ 382 KB 👁 2 views

Assessing the effect of processing varia

Assessing the effect of processing variables on the mechanical response of polysytrene molded using vibration-assisted injection molding process

✍ A. Kikuchi; J. P. Coulter; R. R. Gomatam 📂 Article 📅 2005 🏛 John Wiley and Sons 🌐 English ⚖ 175 KB 👁 2 views

Effect of an obstacle during processing

Effect of an obstacle during processing on the weld line of injection-molded glassy polystyrene: Microhardness study

✍ T. Nguyen-Chung; G. Mennig; M. Boyanova; S. Fakirov; F. J. Baltá Calleja 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 120 KB 👁 2 views

Effect of Processing Parameters on the M

Effect of Processing Parameters on the Mechanical Properties of Injection Molded Thermoplastic Polyolefin (TPO) Cellular Foams

✍ Steven Wong; John W. S. Lee; Hani E. Naguib; Chul B. Park 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 356 KB 👁 1 views

## Abstract In this study, the effects of processing parameters on the mechanical properties of injection molded thermoplastic polyolefin (TPO) foams are investigated. Closed cell TPO foams were prepared by injection molding process. The microstructure of these foamed samples was controlled by care

Experimental Design to Study the Effect

Experimental Design to Study the Effect of APS Process Parameters on Friction Behaviour of Alumina-Titania Coatings

✍ S. Guessasma; M. Bounazef 📂 Article 📅 2004 🏛 John Wiley and Sons 🌐 English ⚖ 282 KB 👁 2 views