✦ LIBER ✦

Experimental investigation of stress and carrying capacity of cast parts for high-pressure pipelines

✍ Scribed by B. N. Dudko; Yu. A. Leont'ev

Publisher: Springer
Year: 1978
Tongue: English
Weight: 338 KB
Volume: 14
Category: Article
ISSN: 0009-2355
DOI: 10.1007/bf01146806

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Manufacture and assemblage of parts for

Manufacture and assemblage of parts for high-pressure pipelines

✍ B. M. Bogdanov 📂 Article 📅 1968 🏛 Springer 🌐 English ⚖ 188 KB

Designing for strength, and experimental

Designing for strength, and experimental investigation of the stressed state of the seal baffle plate in the double conical seal of high-pressure vessels

✍ É. B. Fel'dman; D. G. Malova; O. V. Rumyantsev 📂 Article 📅 1971 🏛 Springer 🌐 English ⚖ 447 KB

ERRATUM: Deep Litter Systems for Beef Ca

ERRATUM: Deep Litter Systems for Beef Cattle Housed in Uninsulated Barns. Part 1: Height Increase, Carrying Capacity and Specific Counter-pressure of Aeration of Deep Litter

📂 Article 📅 2002 🏛 Elsevier Science 🌐 English ⚖ 156 KB

p. 419, the address line should read 'Agrifood Research Finland' in place of 'Agricultural Research,, the index of À1 should be inserted after 'day' to become 'day À1 '. p. 425, the unit of measurement 'kg m À2 ' should read 'kg m À2 day À1 . p. 426, col. 1, line 35, the unit of measurement should b

SE—Structures and Environment: Deep Litt

SE—Structures and Environment: Deep Litter Systems for Beef Cattle housed in Uninsulated Barns, Part 1: Height Increase, Carrying Capacity and Specific Counter-pressure of Aeration of Deep Litter

✍ P. Kapuinen 📂 Article 📅 2001 🏛 Elsevier Science 🌐 English ⚖ 393 KB

For beef cattle housed in uninsulated barns, it is important to design the deep litter area deeper than the dung alley in accordance with the bedding material used. If this step is not taken it may become necessary to remove the deep litter in the middle of winter when, because of cold weather, the

A constitutive model for the dynamic and

A constitutive model for the dynamic and high-pressure behaviour of a propellant-like material: Part I: Experimental background and general structure of the model

✍ Hervé Trumel; André Dragon; Alain Fanget; Philippe Lambert 📂 Article 📅 2001 🏛 John Wiley and Sons 🌐 English ⚖ 462 KB

Load carrying behaviour of the primary s

Load carrying behaviour of the primary system of PWRs for loads beyond the design limits: Part 2: Creep and failure behaviour of a piping section under internal pressure and high temperature

✍ K. Maile; A. Klenk; V. Obst; D. Sturm 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 661 KB