𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Experimental evaluation on the effect of minimal quantities of lubricant in milling

✍ Scribed by M Rahman; A Senthil Kumar; M.U Salam

Book ID
108458061
Publisher
Elsevier Science
Year
2002
Tongue
English
Weight
307 KB
Volume
42
Category
Article
ISSN
0890-6955

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Evaluation of Minimal of Lubricant in En
Evaluation of Minimal of Lubricant in End Milling
✍ M. Rahman; A. Senthil Kumar; Manzoor-UI-Salem πŸ“‚ Article πŸ“… 2001 πŸ› Springer 🌐 English βš– 248 KB

When considering machinability parameters, the use of coolant is indispensable in metal cutting operations. However, stricter environmental regulations are making the use of an ample amount of conventional coolant impossible because of its negative impact on the environment. Consequently, the use of

An experimental investigation of effects
An experimental investigation of effects of cooling/lubrication conditions on tool wear in high-speed end milling of Ti-6Al-4V
✍ Y. Su; N. He; L. Li; X.L. Li πŸ“‚ Article πŸ“… 2006 πŸ› Elsevier Science 🌐 English βš– 319 KB

High-speed machining of titanium alloys generates high cutting temperature in the cutting zone, which decreases tool life rapidly. So the improvement of the tool life in the high-speed machining of titanium alloys very much depends on the effectiveness of the cooling/lubrication provided. In this pa