𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Examining the use of TiO2 to enhance the NH3 sensitivity of polypyrrole films

✍ Scribed by Yan Wu; Shuangxi Xing; Jiacai Fu


Publisher
John Wiley and Sons
Year
2010
Tongue
English
Weight
136 KB
Volume
118
Category
Article
ISSN
0021-8995

No coin nor oath required. For personal study only.

✦ Synopsis


Polypyrrole/Titanium dioxide (PPy/TiO 2 ) composite thin films were prepared by polymerizing the monomer pyrrole in aqueous solution containing a certain amount of TiO 2 particles at room temperature, and their response to ammonia (NH 3 ) gas was examined systematically. Compared with the pristine PPy film, which reached the saturation at the concentration of NH 3 beyond 200 ppm, the composite films showed more stable response and higher sensitivity. Furthermore, the PPy/TiO 2 com-posite thin films exhibited a low detection limit of 2 ppm. The film thickness, which had a strong influence on the film sensitivity to NH 3 , could be controlled by varying the polymerization time. The sensitivity to NH 3 gas of the samples with different content of TiO 2 and different molar ratio of PPy/TiO 2 /oxidant was studied. V


πŸ“œ SIMILAR VOLUMES


Irregular Response of the Polypyrrole Fi
✍ Emese KrivΓ‘n; Csaba Visy; RΓ³bert Dobay; GΓ‘bor HarsΓ‘nyi; OttΓ³ Berkesi πŸ“‚ Article πŸ“… 2000 πŸ› John Wiley and Sons 🌐 English βš– 193 KB
The use of 13C labeling to enhance the s
✍ Kees-Jan Booy; Peter Wiegerinck; Jan Vader; Frans Kaspersen; Dorette Lambregts; πŸ“‚ Article πŸ“… 2005 πŸ› John Wiley and Sons 🌐 English βš– 99 KB πŸ‘ 1 views

13 C labeling was used to enhance the sensitivity of 13 C solid-state NMR to study the effect of tabletting on the polymorphism of a steroidal drug. The steroidal drug Org OD 14 was 13 C labeled and formulated into tablets containing only 0.5-2.5% active ingredient. The tablets were subsequently

Use of surface-modifying macromolecules
✍ Tang, Y. W. ;Santerre, J. P. ;Labow, R. S. ;Taylor, D. G. πŸ“‚ Article πŸ“… 1997 πŸ› John Wiley and Sons 🌐 English βš– 276 KB

Polyurethanes are widely used as biomaterials for medical implants because of their excellent mechanical properties and moderate biocompatibility. However, the demand for more bioresistant and biocompatible polyurethanes to meet the needs of long-term implant devices still remains an important issue