𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Evaluation of the intermetallic compound Al2Ti for elevated-temperature applications

✍ Scribed by J.E. Benci; J.C. Ma; T.P. Feist


Publisher
Elsevier Science
Year
1995
Tongue
English
Weight
863 KB
Volume
192-193
Category
Article
ISSN
0921-5093

No coin nor oath required. For personal study only.


πŸ“œ SIMILAR VOLUMES


Microstructure and creep properties of a
✍ J Lapin; M Nazmy πŸ“‚ Article πŸ“… 2004 πŸ› Elsevier Science 🌐 English βš– 601 KB

The microstructure and creep properties including minimum creep rate, time to 1% creep deformation and creep fracture time of a cast TiAl-based alloy with nominal chemical composition Ti-46Al-2W-0.5Si (at.%) were investigated. The creep specimens were prepared from investment-cast plate and two larg

Energy-based approach for the evaluation
✍ M.D. Callaghan; S.R. Humphries; M. Law; M. Ho; P. Bendeich; H. Li; W.Y. Yeung πŸ“‚ Article πŸ“… 2010 πŸ› Elsevier Science 🌐 English βš– 381 KB

The energy-based approach for the evaluation of low cycle fatigue behaviour of 2.25Cr-1Mo steel at elevated temperature has been investigated and detailed analyses discussed. Plastic strain energy was determined per cycle and found to characterise both crack initiation and propagation to failure reg

Experimental study of H2O spectroscopic
✍ Xiang Liu; Xin Zhou; Jay B. Jeffries; Ronald K. Hanson πŸ“‚ Article πŸ“… 2007 πŸ› Elsevier Science 🌐 English βš– 510 KB

Tunable diode laser (TDL) absorption sensors of water vapor are attractive for temperature, gas composition, velocity, pressure, and mass flux measurements in a variety of practical applications including hydrocarbon-fueled combustion systems. Optimized design of these sensors requires a complete ca

Performance evaluation of counter flow h
✍ Prabhat Gupta; M.D Atrey πŸ“‚ Article πŸ“… 2000 πŸ› Elsevier Science 🌐 English βš– 254 KB

Counter Β―ow heat exchangers are commonly used in cryogenic systems because of their high eectiveness. In addition to operating and design parameters, the thermal performance of these heat exchangers is strongly governed by various losses such as longitudinal conduction through wall, heat in leak fro