𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Epoxy resin/poly(ethyl acrylate)—interpenetrating polymer networks: engineering properties and morphology

✍ Scribed by Bibekananda Das; Debabrata Chakraborty; Asok Hajra


Publisher
Elsevier Science
Year
1994
Tongue
English
Weight
764 KB
Volume
30
Category
Article
ISSN
0014-3057

No coin nor oath required. For personal study only.

✦ Synopsis


A~tract--lnterpenetrating polymer networks were prepared by the sequential mode of synthesis using an epoxy resin as the plastomer and poly(ethyl acrylate), PEA, as the elastomer components, respectively. Two types of IPNs; viz. full and semi, were prepared and characterized by measurements of tensile strength, elongation at break, modulus and toughness. Thermal properties were studied by differential scanning calorimetry and thermogravimetry. The morphological features were studied through scanning electron microscopy and polarized light microscopy. The effects of variation of the blend ratio on the above-mentioned properties were examined. Both semi and full IPNs showed a gradual decrease in modulus and tensile strength with consequent increases in elongation and toughness on increasing the proportion of the elastomeric component, PEA. The full IPNs were, however, characterized by higher modulus and tensile strength. The thermogravimetric results indicated that instead of a stepwise unzipping process of depolymerization as observed with PMMA, a C--C bond scission occurred without formation of free radicals in the case of PEA. The calorimetric results showed one glass transition temperature Tg in between the Tg values of the plastomer and elastomer components suggesting extensive phase mixing. The morphology indicated a higher proportion of dissolved rubber particularly at the lower concentrations of PEA. Phase separated rubber domains being developed at higher concentrations also increased elongation at break since cavitation or crazing was promoted at the interfacial boundary. The elongation was limited to the extent of cavitation and therefore large increases in toughness were not found.


📜 SIMILAR VOLUMES


Epoxy resin–poly(ethyl methacrylate) int
✍ D. Chakrabarty; B. Das; S. Roy 📂 Article 📅 1998 🏛 John Wiley and Sons 🌐 English ⚖ 328 KB 👁 2 views

Full (interpenetrating networks (IPNs)) and semi-IPNs of the epoxy resin and poly(ethyl methacrylate) (PEMA) were prepared by the sequential mode of synthesis. These were characterized with respect to their mechanical properties, namely, tensile strength, elongation at break, modulus, and toughness.

Graft interpenetrating polymer networks
✍ Feng Jun Hua; Chun Pu Hu 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 English ⚖ 248 KB 👁 2 views

For enhancing the interpenetratoin and/or compatibility of the simultaneous interpenetrating networks (SINs) composed of epoxy resin (epoxy) and urethane acrylate resin (UAR), the graft epoxy consisting of different lengths of poly(oxypropylene) (PO) side chains were synthesized and characterized. I

Synthesis and characterization of sequen
✍ Sudipta Goswami; Debabrata Chakrabarty 📂 Article 📅 2006 🏛 John Wiley and Sons 🌐 English ⚖ 387 KB 👁 2 views

## Abstract Interpenetrating polymer networks (IPN) of Novolac/poly(ethyl acrylate) have been prepared via in situ sequential technique of IPN formation. Both full and semi IPNs were characterized with respect to their mechanical properties that is, ultimate tensile strength (UTS), percentage elong