Enhancement of heat transfer in hydrogen storage tank with hydrogen absorbing alloy (optimum fin layout)
✍ Scribed by Yuichi Mitsutake; Masanori Monde; Kengo Shigetaka; Shigeru Tsunokake; Tatsuya Fuura
- Publisher
- John Wiley and Sons
- Year
- 2008
- Tongue
- English
- Weight
- 1018 KB
- Volume
- 37
- Category
- Article
- ISSN
- 1099-2871
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
Optimization of the fin layout in a metal hydride (MH) bed has been sought to enhance poor heat transmission in a hydrogen storage tank, and to obtain a maximum hydrogen absorption rate with a smaller volume of fins. Two different fin configurations, radial and circular fins, in a vertical cylindrical reactor vessel were tested with a La‐Ni‐based AB5 type hydrogen storage alloy. A two‐dimensional transient heat conduction analysis, coupled with predicted temperature and concentration of absorbed hydrogen in the bed for the exothermic hydride reaction, was used to evaluate enhancement of the hydrogen absorption time. The estimated temperature and concentration agreed within 6 K and 8.5%, respectively, with our experimental results. The effect of thickness and the spacing and shape of fins on the hydrogen absorption time were analytically evaluated, so that the optimum range of the each fin layout was obtained by the trade off between absorption time and reduction in the MH volume due to the volume occupied by fins. The hydrogen absorption time for the recommended layout of circular fins was reduced to approximately one‐third of that without fins. © 2008 Wiley Periodicals, Inc. Heat Trans Asian Res, 37(3): 165–183, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/htj.20195