Elongational viscosity for miscible and immiscible polymer blends. I. PMMA and AS with similar elongational viscosity

✍ Scribed by Tatsuhiro Takahashi; Jun-Ichi Takimoto; Kiyohito Koyama

• Publisher: John Wiley and Sons
• Year: 1999
• Tongue: English
• Weight: 395 KB
• Volume: 73
• Category: Article
• ISSN: 0021-8995
• DOI: 10.1002/(sici)1097-4628(19990801)73:5<757::aid-app16>3.0.co;2-o

✦ Synopsis

The effects of miscibility and blend ratio on uniaxial elongational viscosity of polymer blends were studied by preparing miscible and immiscible samples at the same composition by using poly(methyl methacrylate) (PMMA) and poly(acrylonitrileco-styrene) (AS). Miscible polymer blend samples for the elongational viscosity measurement were prepared by using three steps: solvent blends, cast film, and hot press. A phase diagram of blend samples was made by visual observation of cloudiness. Immiscible blend samples were prepared by maintaining the prepared miscible samples at 200°C, which is higher than cloud points using a LCST (lower critical solution temperature) phase diagram. The phase structure of immiscible blends was observed by an optical microscope. The elongational viscosity of all samples was measured at 145°C, which is lower than the cloud-point temperature at all blend ratios. The elongational viscosity of PMMA and AS was similar to each other. The strain-hardening property of miscible blends in the elongational viscosity was only slightly influenced by the blend ratio, and this was also the case with immiscible blends. The strain-hardening property was only slightly influenced, whether it was miscible or immiscible at each blend ratio. Polydispersity in molecular weight for blend samples was not changed by GPC (gel permeation chromatography) analysis. Almost no change in the polydispersity of the molecular weight for blends and the similarity of elongational viscosity between PMMA and AS resulted in little influence of the blend ratio and miscibility on the strainhardening property.