✦ LIBER ✦

Elasto-plastic analysis of interface layers for fiber-reinforced metal-matrix composites

✍ Scribed by I Doghri; F.A Leckie

Publisher: Elsevier Science
Year: 1994
Tongue: English
Weight: 884 KB
Volume: 51
Category: Article
ISSN: 0266-3538
DOI: 10.1016/0266-3538(94)90157-0

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Asymptotic homogenization algorithm for

Asymptotic homogenization algorithm for reinforced metal-matrix elasto-plastic composites

✍ J. Orlik 📂 Article 📅 2010 🏛 Elsevier Science 🌐 English ⚖ 1001 KB

The theory of the two-scale convergence was applied to homogenization of initial flow stresses and hardening constants in some exponential hardening laws for elasto-plastic composites with a periodic microstructure. The theory is based on the fact that both the elastic and the plastic part of the st

Elasto-plastic analysis of an aluminum a

Elasto-plastic analysis of an aluminum alloy matrix reinforced with silicon carbide fibers

✍ P.K. Gotsis; A.H. Shabaik; G.H. Sines 📂 Article 📅 1992 🏛 Elsevier Science 🌐 English ⚖ 643 KB

Development of a new finite element form

Development of a new finite element formulation for the elasto-plastic analysis of fiber-reinforced composites

✍ Y.W. Kwon; K.Y. Byun 📂 Article 📅 1990 🏛 Elsevier Science 🌐 English ⚖ 588 KB

Dependence of initial stress–strain beha

Dependence of initial stress–strain behavior on matrix plastic inhomogeneity in short fiber-reinforced metal matrix composite

✍ X.D Ding; Z.H Jiang; J.S Lian; J Sun 📂 Article 📅 2004 🏛 Elsevier Science 🌐 English ⚖ 252 KB

Numerical analysis of influence of micro

Numerical analysis of influence of micro-parameters on macro-micromechanical properties of fiber reinforced metal matrix composites

✍ Lijuan Hu; Shaorui Zhang; Dayong Li; Qunfeng Chang; Yinghong Peng 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 592 KB

The properties of fiber reinforced metal matrix composites (MMCs) are anisotropic. These properties can be more appropriately evaluated in polar coordinate. In this paper, the elastic-plastic mechanics model of MMCs is presented based on the combination of macroscopic and meso-scopic analysis in pol

Use of submicron diameter carbon filamen

Use of submicron diameter carbon filaments for reinforcement between continuous carbon fiber layers in a polymer-matrix composite

✍ Steven W. Hudnut; D.D.L. Chung 📂 Article 📅 1995 🏛 Elsevier Science 🌐 English ⚖ 454 KB

The incorporation of 0.1-0.2 pm diameter carbon filaments (0.6 vol.%) between continuous carbon fiber (7 pm diameter, 56.5 vol.%) layers in an epoxy-matrix composite during composite fabrication was found under flexure to greatly increase transverse and longitudinal tan 6 values, increase the storag