Efficient high-frequency body coil for high-field MRI
✍ Scribed by J.T. Vaughan; G. Adriany; C.J. Snyder; J. Tian; T. Thiel; L. Bolinger; H. Liu; L. DelaBarre; K. Ugurbil
- Book ID
- 102953759
- Publisher
- John Wiley and Sons
- Year
- 2004
- Tongue
- English
- Weight
- 864 KB
- Volume
- 52
- Category
- Article
- ISSN
- 0740-3194
No coin nor oath required. For personal study only.
✦ Synopsis
Abstract
The use of body coils is favored for homogeneous excitation, and such coils are often paired with surface coils or arrays for sensitive reception in many MRI applications. While the body coil's physical size and resultant electrical length make this circuit difficult to design for any field strength, recent efforts to build efficient body coils for applications at 3T and above have been especially challenging. To meet this challenge, we developed an efficient new transverse electromagnetic (TEM) body coil and demonstrated its use in human studies at field strengths up to 4T. Head, body, and breast images were acquired within peak power constraints of <8 kW. Bench studies indicate that these body coils are feasible to 8T. RF shimming was used to remove a high‐field‐related cardiac imaging artifact in these preliminary studies. Magn Reson Med 52:851–859, 2004. © 2004 Wiley‐Liss, Inc.
📜 SIMILAR VOLUMES
## Abstract We have built and tested a thin‐film high temperature superconducting (HTS) surface coil for MRI at 0.064T. When placed as close as possible to a conductive sample, the 6.7‐cm outer diameter HTS coil had a measured signal‐to‐noise ratio (SNR) 1.8; times higher than a room temperature co
## Abstract A new type of high‐frequency RF surface coil was developed for in vivo proton or other nuclei NMR applications at 7T. This is a purely distributed‐element and transmission line design. The coil consists of a thin strip conductor (copper or silver) and a ground plane separated by a low‐l