✦ LIBER ✦

Effects of evaporator frosting and defrosting on the performance of air-to-water heat pumps

✍ Scribed by S.A. Tassou; C.J. Marquand

Publisher: Elsevier Science
Year: 1987
Tongue: English
Weight: 570 KB
Volume: 28
Category: Article
ISSN: 0306-2619
DOI: 10.1016/0306-2619(87)90038-9

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

Performance of an air-to-air heat pump u

Performance of an air-to-air heat pump under frosting and defrosting conditions

✍ Kamil Kaygusuz 📂 Article 📅 1994 🏛 Elsevier Science 🌐 English ⚖ 683 KB

Effect of short-tube orifice size on the

Effect of short-tube orifice size on the performance of an air source heat pump during the reverse-cycle defrost

✍ Dennis L O'Neal; Kurt Peterson; N.K Anand 📂 Article 📅 1991 🏛 Elsevier Science 🌐 English ⚖ 693 KB

An experimental study on the operating p

An experimental study on the operating performance of a novel reverse-cycle hot gas defrosting method for air source heat pumps

✍ Hu Wenju; Jiang Yiqiang; Qu Minglu; Ni Long; Yao Yang; Deng Shiming 📂 Article 📅 2011 🏛 Elsevier Science 🌐 English ⚖ 913 KB

Effects of heat transfer and friction on

Effects of heat transfer and friction on the performance of an irreversible air-standard miller cycle

✍ Yanlin Ge; Lingen Chen; Fengrui Sun; Chih Wu 📂 Article 📅 2005 🏛 Elsevier Science 🌐 English ⚖ 225 KB

The use of LabVIEW and data acquisition

The use of LabVIEW and data acquisition unit to monitor and control a bench-top air-to-water heat pump

✍ H. I. Abu-Mulaweh; D. W. Mueller 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 229 KB

Kinetics of water adsorption on loose gr

Kinetics of water adsorption on loose grains of SWS-1L under isobaric stages of adsorption heat pumps: The effect of residual air

✍ I.S. Glaznev; Yu.I. Aristov 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 290 KB

In this paper we studied the effect of a non-adsorbable gas (air) on kinetics of water adsorption on loose grains of the composite adsorbent SWS-1L (silica modified by calcium chloride) (grain size 0.8-0.9 and 1.4-1.6 mm). The adsorbent grains were placed on the surface of isothermal metal plate at