𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Effects of annealing time and temperature on the crystallinity and heat resistance behavior of injection-molded poly(lactic acid)

✍ Scribed by Yottha Srithep; Paul Nealey; Lih-Sheng Turng

Book ID
115560846
Publisher
Society for Plastic Engineers
Year
2012
Tongue
English
Weight
839 KB
Volume
53
Category
Article
ISSN
0032-3888

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Effects of physical aging, crystallinity
Effects of physical aging, crystallinity, and orientation on the enzymatic degradation of poly(lactic acid)
✍ Hua Cai; Vipul Dave; Richard A. Gross; Stephen P. McCarthy πŸ“‚ Article πŸ“… 1996 πŸ› John Wiley and Sons 🌐 English βš– 827 KB

The effects of physical aging, degree of crystallinity, and orientation of poly(1actic acid) (PLA) were studied using differential scanning calorimetry (DSC) and wide angle X-ray scattering (WAXS). The samples of PLA with 96% [L] and 4% [ D ] contents were prepared by injection molding. The physical

Effects of Stereocomplex Nuclei or Spher
Effects of Stereocomplex Nuclei or Spherulites on Crystalline Morphology and Crack Behavior of Poly(L-lactic acid)
✍ Siti Nurkhamidah; Eamor M. Woo πŸ“‚ Article πŸ“… 2011 πŸ› John Wiley and Sons 🌐 English βš– 1013 KB

## Abstract Introduction of sc‐PLA crystals as small nuclei or large sc‐PLA spherulites has great influence on patterning the inter‐phase boundaries and reducing the cracks in crystallized PLLA in mixtures with PDLA. Unmelted sc‐PLA crystals as nuclei induce cracks in later‐crystallized PLLA, where

Effect of Melt and Mold Temperatures on
Effect of Melt and Mold Temperatures on the Solidification Behavior of HDPE during Gas-Assisted Injection Molding: An Enthalpy Transformation Approach
✍ Bin Yang; Xiao-Rong Fu; Wei Yang; Shui-Po Liang; Nan Sun; Sheng Hu; Ming-Bo Yang πŸ“‚ Article πŸ“… 2009 πŸ› John Wiley and Sons 🌐 English βš– 532 KB

## Abstract The influence of melt and mold temperature on the solidification behavior of HDPE during the GAIM process is studied using a transient‐heat‐transfer model of the enthalpy transformation approach. An in situ measurement of temperature decay in the mold cavity was carried out to verify th