𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Effect of Wire-EDM Machining Parameters on Surface Roughness and Material Removal Rate of High Strength Armor Steel

✍ Scribed by Bobbili, Ravindranadh; Madhu, V.; Gogia, A. K

Book ID
121325653
Publisher
Taylor and Francis Group
Year
2013
Tongue
English
Weight
443 KB
Volume
28
Category
Article
ISSN
1042-6914

No coin nor oath required. For personal study only.

πŸ“œ SIMILAR VOLUMES

Effects of wire-EDM machining variables
Effects of wire-EDM machining variables on surface roughness of newly developed DC 53 die steel: Design of experiments and regression model
✍ K. Kanlayasiri; S. Boonmung πŸ“‚ Article πŸ“… 2007 πŸ› Elsevier Science 🌐 English βš– 311 KB

DC53 is a newly developed cold die steel from Daido Steel, Japan. It is an improvement over the familiar cold die steel SKD11. Because DC53 is a new die steel, only little information is available in literature for its machining characteristics. This paper presents an investigation of the effects of