𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Effect of the application of uniaxial stress on precipitation in an Al(Cu) alloy

✍ Scribed by S. Kawarazaki; N. Kunitomi; R.M. Nicklow; H.G. Smith

Publisher
Elsevier Science
Year
1983
Weight
250 KB
Volume
120
Category
Article
ISSN
0378-4363

No coin nor oath required. For personal study only.

📜 SIMILAR VOLUMES

The effect of iron on the precipitation
The effect of iron on the precipitation in an Al-Mg-Si alloy
✍ Dr. U. Schmidt; M. Joachimi; L. Petzold; Dr. F. Eichhorn 📂 Article 📅 1984 🏛 John Wiley and Sons 🌐 English ⚖ 523 KB

The effect of iron on the precipitation of a technical Al-Mg-Si alloy was studied by macroand microhardness, Y-modulus and SANS with D K D and was coinpared with a pure alloy. The iron phases of the technical alloy were preferentially considered by the SANS. I n addition the daniping by the elastoma

On the growth of Widmanstätten precipita
On the growth of Widmanstätten precipitates in an Al–Cu alloy
✍ Yan Li; Gary Purdy 📂 Article 📅 2008 🏛 Elsevier Science 🌐 English ⚖ 288 KB

The formation of intragranular h 0 disk-shaped precipitates in Al-Cu alloys is accompanied by a thickness-dependent misfit strain. In this study, the lengthening rates of Widmansta ¨tten h 0 precipitates of two different thicknesses (1.2 and 2.0 nm) are compared. It is shown experimentally that the

The precipitation of θ' at high-angle bo
The precipitation of θ' at high-angle boundaries in an Al-Cu alloy
✍ D Vaughan 📂 Article 📅 1970 🏛 Elsevier Science ⚖ 678 KB

In the AI-Cu system precipitates of the intermediate 0' phase generally nualeate at low-angle boundaries and precipitates of the equilibrium 0 phase form at high-angle boundaries. A few exceptions oocur where 8' precipitates form at high-angle boundaries and these have been studied by transmission e