𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Effect of temperature on the Electrochemical corrosion behaviour of titanium

✍ Scribed by Dr. Á. Rauscher; Z. Lukács


Publisher
John Wiley and Sons
Year
1988
Tongue
German
Weight
312 KB
Volume
39
Category
Article
ISSN
0947-5117

No coin nor oath required. For personal study only.


📜 SIMILAR VOLUMES


Effect of the heating temperature on the
✍ D. Krupa; J. Baszkiewicz; J. Mizera; T. Borowski; A. Barcz; J. W. Sobczak; A. Bi 📂 Article 📅 2009 🏛 John Wiley and Sons 🌐 English ⚖ 427 KB 👁 1 views

## Abstract The paper presents the results of examinations of the corrosion resistance of titanium after its being subjected to the surface modification by the alkali‐ and heat‐treatments. The material examined was commercially pure titanium (grade 2). The samples were soaked in an aqueous 10__M__

The effect of copper and ferric sulfates
✍ I. P. Anoshchenko; B. P. Ignatov; G. I. Lukyanova; V. V. Pyaterikov 📂 Article 📅 1974 🏛 John Wiley and Sons 🌐 German ⚖ 228 KB 👁 1 views

## Abstract The influecne of Cu‐ and Fe‐III sulfates has been investigated by potentiodynamic and gravimetric methods. The results show that there are effective (critical) inhibitor concentrations. According to the results obtained both salts inhibit the corrosion of titanium in phosphoric acid at

pH effect on the potentiodynamic behavio
✍ Dr. M. W. Khalil; M. A. Abdel Rahim 📂 Article 📅 1991 🏛 John Wiley and Sons 🌐 English ⚖ 450 KB

## Abstract Potentiodynamic measurements on mechanically polished titanium electrodes were performed in different solutions in the pH range 0.55–12. Two anodic peaks and one small cathodic peak were observed. Comparison with thermodynamic data revealed the possibility of formation of Ti~2~O~3~ or T

Effects of pH and fluoride concentration
✍ B. Lindholm-Sethson; B.I. Ardlin 📂 Article 📅 2008 🏛 John Wiley and Sons 🌐 English ⚖ 348 KB 👁 1 views

## Abstract The aim of this investigation was to confirm and summarize the corrosion behavior of titanium in saline solution at different pH and fluoride concentration, and to characterize the surface films and the stability of a passive and aged titanium surface using open circuit potential measur