Effect of hot drawing on properties of wet-spun poly(L,D-lactide) copolymer multifilament fibers

✍ Scribed by Marja Rissanen; Arja Puolakka; Terttu Hukka; Ville Ellä; Minna Kellomäki; Pertti Nousiainen

• Publisher: John Wiley and Sons
• Year: 2010
• Tongue: English
• Weight: 421 KB
• Volume: 115
• Category: Article
• ISSN: 0021-8995
• DOI: 10.1002/app.31015

✦ Synopsis

Abstract

Polylactide stereocopolymer multifilament fibers were prepared by wet spinning and subsequent hot drawing. The stereocopolymers were poly‐(L,D‐lactide) [P(L,D)LA], L/D ratio 96/4, and poly‐(L,DL‐lactide) [P(L,DL)LA], L/DL ratio 70/30. They were dissolved in dichloromethane and coagulated in a spin bath containing ethanol. The hot‐drawing temperature was 65°C. The draw ratios (DR) were upto 4.5 to the P(L,D)LA 96/4 filaments and upto 3 to the P(L,DL)LA 70/30 filaments. Wet spinning decreased crystallinities of both copolymers. Hot drawing increased the crystallinity of the P(L,D)LA 96/4 filament but not to the level of the original copolymer, whereas the as‐spun and the hot‐drawn P(L,DL)LA 70/30 filaments were amorphous. The filament diameter, tenacity, Young's modulus, and elongation at break were dependent on the DR. The maximum tenacity (285 MPa) and Young's modulus (2.0 GPa) were achieved with the P(L,D)LA 96/4 filament at the DR of 4.5. Respectively, the maximum tenacity of the hot‐drawn P(L,DL)LA 70/30 filament was 175 MPa and Young's modulus 1.3 GPa at the DR of 3. Hot drawing slowed down in vitro degradation rate of both stereocopolymer filaments. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010