✦ LIBER ✦

Effect of hand mixing tobramycin on the fatigue strength of Simplex P

✍ Scribed by Davies, Jeffrey P. ;Harris, William H.

Publisher: John Wiley and Sons
Year: 1991
Tongue: English
Weight: 370 KB
Volume: 25
Category: Article
ISSN: 0021-9304
DOI: 10.1002/jbm.820251108

No coin nor oath required. For personal study only.

✦ Synopsis

In a recent study, we showed that the presence of gentamicin in Palacos R or erythromycin plus colistin in Simplex P bone cement did not significantly decrease the fatigue strength of the cement.

📜 SIMILAR VOLUMES

The effect of the addition of methylene

The effect of the addition of methylene blue on the fatigue strength of simplex P bone–cement

✍ Jeffrey P. Davies; Dr. William H. Harris 📂 Article 📅 1992 🏛 Wiley (John Wiley & Sons) 🌐 English ⚖ 443 KB 👁 1 views

## Abstract To aid in cement removal during revision arthroplasty, it has been proposed to add methylene blue to bone cement to provide contrast between the cement and bone. However, it is essential that the fatigue strength of the cement not be reduced by the addition of the methylene blue. The ef

The effect of heat treatment on the fati

The effect of heat treatment on the fatigue strength of microknurled Ti-6Al-4V

✍ Bourassa, P. Louis ;Yue, Steve ;Bobyn, J. Dennis 📂 Article 📅 1997 🏛 John Wiley and Sons 🌐 English ⚖ 476 KB 👁 2 views

Microknurling, a high pressure surface indentation technique, was devised as an alternative to traditional heat-bonded porous coatings found on many orthopedic implants designed for fixation by tissue ingrowth. Heat-bonded porous coating can cause at the surface of an implant stress concentrations t

Relative roles of cement molecular weigh

Relative roles of cement molecular weight and mixing method on the fatigue performance of acrylic bone cement: Simplex�P versus Osteopal�

✍ Lewis, Gladius 📂 Article 📅 2000 🏛 John Wiley and Sons 🌐 English ⚖ 260 KB 👁 3 views

The weight-average molecular weight (MW(w)) of a cement and the method used to mix its powder and liquid monomer constituents have been identified in the literature as key variables that affect mechanical properties of the fully polymerized cement that are relevant to its performance as a grouting a

The effect of a thin coating of polymeth

The effect of a thin coating of polymethylmethacrylate on the torsional fatigue strength of the cement-metal interface

✍ Jeffrey P. Davies; Gordon Singer; Dr. William H. Harris 📂 Article 📅 1992 🏛 Wiley (John Wiley & Sons) 🌐 English ⚖ 477 KB 👁 1 views

Recent studies have established that a mechanism of initiation of failure of fixation of cemented femoral components is debonding of the cement-metal interface. Other studies have shown that the torsional forces induced by stair climbing and rising from a chair are very high. Thus, the interface bet

The effect of fatigue on the nuclei of v

The effect of fatigue on the nuclei of voluntary muscle cells

✍ Gilman, P. K. 📂 Article 📅 1903 🏛 Wiley (John Wiley & Sons) 🌐 English ⚖ 268 KB 👁 2 views

Effect of mixing method and storage temp

Effect of mixing method and storage temperature of cement constituents on the fatigue and porosity of acrylic bone cement

✍ Lewis, Gladius 📂 Article 📅 1999 🏛 John Wiley and Sons 🌐 English ⚖ 171 KB 👁 3 views

The influence of the storage temperature of the cement constituents prior to mixing (21 vs. 4 degrees C) and the mixing method (hand mixing vs. vacuum mixing) on the uniaxial tension-compression fatigue performance and porosity of Palacos R acrylic bone cement was studied. The fatigue results were a