𝔖 Bobbio Scriptorium
✦   LIBER   ✦

Effect of environment on crack growth in graphite

✍ Scribed by S.W Freiman; J.J Mecholsky

Publisher
Elsevier Science
Year
1975
Tongue
English
Weight
129 KB
Volume
13
Category
Article
ISSN
0008-6223

No coin nor oath required. For personal study only.

✦ Synopsis

initiation and propagation mechanisms under tensile 45045 Orleans, France). No long or short abstract loading. These results were used in developing an submitted. analytical model for tensile failure based on microstructural parameters and micromechanical principles. 61. Structural evolution of a glassy carbon with the heat treatment between 1000 and 2700Β°C

πŸ“œ SIMILAR VOLUMES

Effect of hold time and environment on F
Effect of hold time and environment on Fatigue Crack Growth Rate in Ti Alloys
✍ Dr. D. Munz; V. Bachmann πŸ“‚ Article πŸ“… 1980 πŸ› John Wiley and Sons 🌐 English βš– 491 KB

## Abstract In titanium alloys an effect of hold time at maximum load in a cyclic test is observed if K~max~ exceeds the threshold for crack propagation at a constant load test. For tests in air it is possible to predict crack growth rate for a hold time cycle from the crack growth rates from a cyc

The effect of pre-stress cycles on fatig
The effect of pre-stress cycles on fatigue crack growthβ€”an analysis of crack growth mechanism
✍ Tai Shan Kang; H.W. Liu πŸ“‚ Article πŸ“… 1974 πŸ› Elsevier Science 🌐 English βš– 561 KB

Cychc pre-stress increases subsequent fatigue crack growth rate in 2024-T3Sl ahrminum ahoy. This increase in growth rate, caused by the pre-stress, and the increased rate, caused by temper embrittlement as observed by Ritchie and Knott, cannot be explained by the crack tip blunting model alone. Each

Effect of stabilization on creep crack g
Effect of stabilization on creep crack growth in high-density polyethylene
✍ G. Pinter; R. W. Lang πŸ“‚ Article πŸ“… 2003 πŸ› John Wiley and Sons 🌐 English βš– 356 KB πŸ‘ 2 views

## Abstract Polyolefins, particularly polyethylene, are known to fail via crack initiation and crack propagation when exposed to multiaxial long‐term static stresses at elevated temperatures. Using concepts of linear elastic fracture mechanics, this article describes and discusses the effects of st