## Abstract Large gain enhancement in a novel long‐wavelength band (L‐band) erbium‐doped fiber amplifier (EDFA) is demonstrated by the cascade of pumped and unpumped erbium‐doped fibers. By utilizing an injected conventional wavelength band (C‐band) laser as an auxiliary pump signal, an approximate
Effect of doped-fiber's spooling on performance of S-band EDFA
✍ Scribed by H. Ahmad; N.K. Saat; S.W. Harun
- Publisher
- John Wiley and Sons
- Year
- 2005
- Tongue
- English
- Weight
- 150 KB
- Volume
- 2
- Category
- Article
- ISSN
- 1612-2011
No coin nor oath required. For personal study only.
✦ Synopsis
The effect of doped-fiber's spooling on performance of
short wavelength band erbium-doped fiber amplifier (S-band EDFA)
is demonstrated. Changing the spooling diameter resulted in a
variation of gain and noise figure characteristics of this
amplifier. The optimum spooling diameter is obtained in the range
from 5 to 7 cm. Beyond this range, an inevitable degradation of
gain and noise figure characteristics is observed due to the
changes of phase matching wavelength. Therefore, maintaining the
optimum spooling diameter is the important issue for the S-band
EDFA.
📜 SIMILAR VOLUMES
The effect of stimulated Raman scattering (SRS) in remote pumping scheme for L-band erbium-doped fiber amplifier (EDFA) was studied in this experiment. Observation was done on the gain and noise figure performance as well as the Raman distributed gains of the remotely-pumped L-band erbium-doped fibe
## Abstract An examination of conversion gain compression impact on mixer performance at 65 GHz demonstrates that the compression properties of upconverters are inherently worse than those of downconverters, and that narrow‐gate devices (when used in downconverters) and wide‐gate devices (when used
## Abstract The purpose of this study was to compare the validity of the 15‐item Geriatric Depression Scale (GDS‐15) in nonelderly (<65 years), young‐elderly (age, 65–75), and old‐elderly (>75 years) patients with Parkinson's disease (PD). 57 nonelderly, 88 young‐elderly, and 81 old‐elderly PD pati
## Abstract Sol–gel method under dip coating process and tetra‐__n__‐butyle orthotitanate as precursor were used to produce titanium oxide coating on steel CK45. The effect of calcination at 400 °C, after drying at 120 °C, on the morphology and corrosion performance of the coatings was investigated